1) temperature stablizing time
温度稳定时间
2) ageing rate and TCFr
时间和温度稳定性
4) stabilization time
稳定时间
1.
This paper deducts the essence formula of calculating the stabilization time, based on the downhole flow equation and requirement of diffe.
根据气井井底流动方程和气井产能试井对测试井井底压降率精度的要求,推导出了计算稳定时间的基本公式,由此便可计算出相应的井底稳定流动压力,进而建立气井的产能方程和确定气井产能,并通过实例分析证明了该法的正确性和可靠性。
5) stability time
稳定时间
1.
The results showed that the diameter and the volume of steamed bread had great positive correlation with the gluten content in wheat flour,that the ratio of diameter and height of steamed bread had great negative correlation with dough stability time,and that the volume and height of steamed bread had good correlation with sedimentation value.
结果表明 :小麦粉面筋含量与馒头的直径和体积高度相关 ;稳定时间与馒头的扩展比极显著负相关 ;沉降值与馒头的高度和体积相关性显著。
2.
Based on many year's practice and referring to research restults abroad,the relations between baking quality and dough development time and stability time were examined and analyzed.
根据多年的实践经验，参考国外有关研究结果，对小麦烘烤品质与面团形成和稳定时间的关系进行了分析探讨。
3.
The results were as follows:(1) Disease incidence was positively correlative with development time,stability time and evaluation value,and the correlative coefficient reached 1% or 5% level.
结果表明:(1)形成时间、稳定时间、评价值与小麦条锈病普遍率间存在正相关性,相关系数达到显著或极显著水平;(2)品质性状中稳定时间是影响小麦条锈病的最主要自变量,加强小麦品种稳定时间的选择在一定程度上可降低小麦品种(系)的抗条锈性水平。
6) steady time
稳定时间
1.
The steady time is independent of the superficial velocity and porous media thickness, while the the burner operates at a certain temperature.
在多孔介质的类型和运行温度不变的情况下,往复式多孔介质燃烧器的压降与空截面流速的平方成正比,与多孔介质的厚度成正比;燃烧器的稳定时间基本不受多孔介质厚度和空截面流速的影响。
2.
In order to reduce influence of nonlinear factors (force ripple, load disturbance and so on) on steady time of a planar High Speed/High Precision Parallel Robot, we design a novel fuzzy self tuning PID controller.
针对推力波动、负载变化等非线性因素对高速高精度平面并联机器人系统稳定时间的影响 ,本文设计了一种新颖的模糊自调整PID控制器 :系统的位置偏差较大时 ,采用PI控制器 ,保证系统的平滑、稳定 ;当系统发出停止命令后 ,引入模糊增益参数自调整机构 ,加快静差消除 。
3.
Then,built up the math model to calculate the steady time of batch ink feeding system and continuous ink feeding system,and the relation between steady time and ink feeding system was studied in depth.
通过对输墨系统的离散化处理,实现了输墨系统的计算机仿真计算,建立了求解间歇式供墨和连续式供墨的稳定时间数学模型,并深入研究了系统的稳定时间与供墨方式的关系。
补充资料：老化温度-时间曲线
分子式：
CAS号：
性质：用以求取高分子材料的耐热老化寿命。老化寿命τ值与温度间有如下关系:lnτ=ΔE/RT+B式中，ΔE为反应活化能；T为热力学温度；R为气体常数；B为常数。通过几个温度点做实验，获得各温度点在老化过程中，有关性能变化与时间关系的动力学曲线图。由此求出各温度点达到特定老化状态时的时间，即寿命值τ。
CAS号：
性质：用以求取高分子材料的耐热老化寿命。老化寿命τ值与温度间有如下关系:lnτ=ΔE/RT+B式中，ΔE为反应活化能；T为热力学温度；R为气体常数；B为常数。通过几个温度点做实验，获得各温度点在老化过程中，有关性能变化与时间关系的动力学曲线图。由此求出各温度点达到特定老化状态时的时间，即寿命值τ。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条