1) Initial intensity
初始强度
2) Virgin Static Strength
初始静强度
1.
By using reliability design methods, minimal reliability of virgin static strength of steel thin wall cylinder during pressure test is quantitative analyzed.
应用可靠性设计方法 ,对压力试验时钢制薄壁内压圆筒形容器初始静强度的最小可靠度进行了定量分析。
2.
By using reliability design methods,minimal reliability of virgin static strength of flat ribbon-wound pressure vessels at pressure test is quantitative analyzed.
应用可靠性设计方法,对压力试验时扁平绕带式容器初始静强度的可靠度进行定量分析。
3.
By using reliability design method, the reliability range of virgin static strength of spherical vessel was quantitatively analyzed under the most severe pneumatic and hydraulic test conditions.
应用可靠性设计方法,在最苛刻的气压与液压试验条件下,对球形容器初始静强度的可靠度范围进行了定量分析;结果表明:①初始屈服强度在气压试验时的可靠度为Rs1=94。
3) started bonding strength
初始粘接强度
1.
The emulsion of acrylates for PVC composite film is prepared and the influences of emulsifier, reaction temperature and time are discussed; The started bonding strength of the emulsion to PVC film can be raised by addtion of the high quality tacky resin.
合成了一种丙烯酸酯乳液 ,考察了反应条件对乳液性能的影响 ;通过加入改性增粘树脂以提高乳液对PVC薄膜的初始粘接强度。
4) Initial call strength
初始呼叫强度
5) initial stress strength ratio
初始应力强度比
6) initial brightness
初始亮度
1.
With initial brightness and afterglow time as indexes,the effects of calcining heat,mass ratio of urea and nitrate,boric acid mole fraction,mol ratio of Dy and Eu on the preparation technology are discussed.
为了探讨SrA l2O4:Eu2+,Dy3+磷光体的最佳制备工艺,利用正交设计法对合成条件进行了优化,以初始亮度和余辉时间为指标,考察煅烧温度、尿素与硝酸盐的质量比、硼酸的物质的量分数、镝与铕物质的量比对制备工艺的影响。
补充资料：初始强度
分子式：
CAS号：
性质：模塑浇注料经初步熟化形成乳酪状，具有一定强度，才能从模具中取出，以保证制品不受损伤、变形，此称为初始强度。模件脱模后经过一定时间的后熟化，才能达到最大强度。
CAS号：
性质：模塑浇注料经初步熟化形成乳酪状，具有一定强度，才能从模具中取出，以保证制品不受损伤、变形，此称为初始强度。模件脱模后经过一定时间的后熟化，才能达到最大强度。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条