说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> Taylor稳定性
1)  Taylor stability
Taylor稳定性
1.
Based on the theory of Taylor stability,theoretical discussion on the changing law of movement toward incompressible cylinder liquid-gas interface had been carried out in this paper,On this basis,the paper analyzed whether the shock-wave strength of blasting had obvious influence on the stability of liquid-gas interface,and demonstrated the theoretical analysis by the result of experiment.
该文根据Taylor稳定性理论,对不可压缩柱面流体界面的运动变化规律进行了理论探讨,在此基础上分析了爆炸冲击波强度对液-气界面的稳定性的影响,并用实验结果对理论分析进行了验证。
2)  Rayleigh-Taylor instability
Rayleigh-Taylor不稳定性
1.
Comparison between Rayleigh-Taylor instability growth rates of compressible and incompressible fluid is made, with the state equation of compressible fluid in an arbitrary function form of density and pressure.
对比研究了可压缩与不可压缩流体的Rayleigh-Taylor不稳定性小扰动阶段的增长速率,其中可压缩流体的状态方程为压力是密度的任意单值函数。
2.
High order weighted essentially non-oscillatory finite difference schemes(FD-WENO) are applied successfully to numerical simulation of gravity-driven high density ratio Rayleigh-Taylor instability problems and laser ablative Rayleigh-Taylor instability problems in two dimensions.
用高阶加权本质上无振荡有限差分格式(FD-WENO),求解重力作用下高密度比二维流体界面Rayleigh-Taylor不稳定性问题及激光烧蚀Rayleigh-Taylor不稳定性问题,均获得较为理想的数值结果。
3.
Rayleigh-Taylor instability problem is simulated by using discontinuous finite element method which is developed for Euler equations with an additional body force corresponding to the gravity.
采用发展后的间断有限元方法,对Rayleigh-Taylor不稳定性进行了数值模拟。
3)  Taylor theorem
Taylor定理
1.
By discussing the asymptoticality of the "center point" in the Taylor theorem of two--vari--able function when point B(x_0 + h, y_0 + k) approaches point A(x_0,y_0) along line segmentAB,the asymp--totic estimation formulas are obtained under ueaker conditions.
讨论了二元函数Taylor定理的“中间点”当点 B(x_0+h,y_0+k)沿直线段AB趋近于点A(x_0,y_0)时的渐进性质,在较弱条件下获得了渐近估计式,从而把文献中的有关结果推广到了二元数的Taylor定理中。
2.
The inverse problems of Differential Mean Value Theorem were studied, including Lagrange theorem and Taylor Theorem.
研究了Lagrange定理和Taylor定理的逆问题 ,证明了在一定的条件下 ,Lagrange定理和Taylor定理的逆定理成立 ,为更好地利用微分中值定理提供了理论根
3.
By using modulus of functiond coutinuity, Two Estimates of the asymptoticrate of convergence for Intermediate point of the Taylor theorem are given.
利用函数连续模给出Taylor定理中间点收敛速度的两个估计。
4)  taylor linearization
Taylor线性化
5)  stability quality
稳定特性;稳定性
6)  steady-state stability
稳态稳定性
1.
A definition on steady-state stability for PWM systems is given and it is proved that many applied proportional PWM systems in the industrial controlled process are with steady-state stability.
在控制系统的脉宽调制器采样间隔可变的条件下,讨论了脉冲调宽系统的稳定性,给出了该类系统具有稳态稳定性的定义,并且证明了在工业控制过程中大量应用的比例型脉冲调宽系统具有稳态稳定性。
2.
The steady-state stability of the system is defined and proved under the condition of variable sampling timelike interval, which is also applied to pluse-width-modulated control system of aptotic sampling period.
对于线性脉冲调宽控制系统给出了更一般的HDS(混合动态系统)的模型,在采样时间间隔为时变的情况下给出了系统的稳态稳定性的定义和证明。
补充资料:连续性与非连续性(见间断性与不间断性)


连续性与非连续性(见间断性与不间断性)
continuity and discontinuity

11an父ux泊g四f“山。麻以角g、.连续性与非连续性(c。nt,n琳t:nuity一)_见间断性与不间断性。and diseo红ti-
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条