说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 李萨如
1)  the pattern of LISARU
李萨如
1.
And the experiment of how to measure the frequency of the tuning fork by the pattern of LISARU is designed.
介绍李萨如图形的形成原理以及如何利用李萨如图形来测量音叉频率的实验。
2)  Lissajous figure
李萨如图
1.
Comparing the fore-and-aft two grating images of worktable movement and adopting phase difference ratio arithmetic based on Lissajous figures,their phase difference can be figured out.
通过CCD(charge coupled device)获取光栅刻线图像,对图像进行分析处理,计算出栅距与图像像素之间的映射系数,再通过对工作台移动前后光栅图像的对比,采用基于李萨如图的相位差比率算法获取它们的像素位置差,从而计算出工作台的实际运行位移量。
2.
The scanner applies widely,such as demonstrating stationary wave,resonance,and Lissajous figure and so on.
由于机械扫描振子在振动区间存有一共振峰,故提出了采用选频放大器驱动电路消除振子在振动区间的非线性的设计,并应用于演示弦线驻波、共振和李萨如图等实验中。
3.
Then,these calculated data are elaborately converted into a Lissajous figure by pixel translation.
将光栅图像灰度值之和形成一组周期固定的准正弦信号,通过像元平移把图像条纹灰度值变为李萨如图。
3)  Lissajous figures
李萨如图
1.
the method of Lissajous figures.
分析了激光陀螺捷联惯导系统产生圆锥运动的原因,给出了估计圆锥误差的一般方法,并在此基础上给出了一种简单、实用的方法---李萨如图法,后者比前者更加接近工程应用。
4)  Lisaru circle
李萨如圆
5)  Lissajous figure
李萨如图形
1.
Theoretical and experimental research of Lissajous figures of square wave;
与方波合成有关的李萨如图形的实验与理论研究
2.
Demonstrating Lissajous figure by spring oscillator;
利用弹簧振子演示李萨如图形
3.
Dynamic Demonstration Program for Lissajous Figure Using VB;
用VB制作李萨如图形动态演示程序
6)  Lissajous figures
李萨如图形
1.
The formulae of measuring the frequency of an alternating signal through Lissajous figures are revised.
通过对变化的李萨如图形的研究 ,给出了图形周期性变化的变化频率与输入信号频率之间的定量关系 ,推导出了利用李萨如图形测量交流信号频率测频公式的修正公式 ,并通过实验验证了修正公式的正确性。
2.
The principle of Lissajous figures was introduced.
对应用MATLAB计算机语言编写李萨如图形演示软件进行了研究,在介绍了李萨如图形形成机理的基础上,编写了用于演示李萨如图形的图形用户界面,最后介绍了李萨如图形的实际应用。
3.
The author clarifies the confused phenemena existed in Lissajous Figures by defining the new terms This article makes a further test to prove author s main conclusion.
用命名新名词的办法,澄清了在李萨如图形中存在的混乱现象。
补充资料:李翰如
Li Hanru
李翰如

(1917~1987)
[]  中国农业工程学家、教育家。1917年生于湖南省湘潭县,1987年3月11日卒于北京。1941年毕业于西北农学院,1945年赴美国艾奥瓦州立大学学习,获农业工程硕士学位。1948年回国后曾任国民政府机械农垦处技术专员。中华人民共和国成立后,历任华北农业机械总厂工程师、室主任,北京农业大学、北京农业机械化学院教授、副院长、博士研究生导师,中国农业机械学会副理事长。50年代在研究设计和推广韧铁焖炉和用计划图表组织农业机械的成批生产方面取得成绩。编译了《农业机械学》共3卷,主编和编写了《农业机械构造》、《农业机械学》、《英汉农业机械辞典》、《简明农业机械化辞典》等,其中,《农业机械学》一书,是中国最早的农业机械专著和教材之一。还曾发表学术论文20余篇。
                 李冬庭
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条