1) erosional exhumation
侵蚀剥露
2) erosion
[英][i'rəuʒən] [美][ɪ'roʒən]
磨蚀,浸蚀,磨损,水蚀,冲蚀,清蚀,侵蚀[作用],剥蚀
3) Exhumation
[英][,ekshju:'meiʃən] [美][,ɛkshju'meʃən]
剥露
1.
Exhumation and Paleotopography Reconstruction in Dabie Orogen Since Late Cretaceous;
大别造山带晚白垩世以来的剥露作用及古地形再造
4) denudation
[英][,di:nju:'deiʃən] [美][,dɪnju'deʃən]
剥露
1.
This paper mainly presents the results of apatite fission-track dating and discusses the Mesozoic uplift-denudation event in the Ili basin.
本文利用砂岩中磷灰石的裂变径迹方法,研究了伊犁盆地中生代抬升-剥露事件。
5) exfoliation corrosion
剥蚀
1.
By means of hardness tests, optical microscopy(OM) and transmission electron microscopy(TEM),effect of the amount of deformation before ageing on microstructure and exfoliation corrosion resistance of 2519 alloy was investigated.
采用金相观察、硬度测试与透射电镜等方法,研究了时效前冷轧预变形量对2519铝合金晶界无沉淀带及析出相大小、分布和抗剥蚀性能的影响。
2.
The effect of tensile stress on exfoliation corrosion of a two-step over-aged 7075 Al alloy was investigated,and the Electrochemical Impedance Spectroscopy (EIS) of 7075 Al alloy in EXCO solution was studied.
研究了拉应力对双级过时效 (12 1℃ /35h +16 0 /2 0h ) 70 75铝合金剥蚀的影响及合金在EXCO溶液中的电化学阻抗谱 。
3.
Studies on intergranular corrosion and exfoliation corrosion of 2xxx,7xxx series aluminum alloys and Al-Li alloys are reviewed.
综述了近几十年来国内外在2xxx系和7xxx系铝合金及Al-Li合金的晶间腐蚀和剥蚀等研究方面的主要进展。
6) exfoliation
[英][eks,fəuli'eiʃən] [美][ɛks,folɪ'eʃən]
剥蚀
1.
The corrosion behavior of 2D12 alloy was evaluated including intergranular corrosion,exfoliation and stress corrosion cracking.
对不同规格2D12铝合金进行晶间腐蚀、剥蚀和应力腐蚀性能测定。
2.
For AA8090 alloy without exfoliation, the EIS is comprised by a depressed capacitive arc at high frequency and an inductive arc at low frequency, and the inductive component weakens and also disappears with time.
结果表明,剥蚀发生之前,AA8090合金电化学阻抗谱由一个压缩的高频容抗弧和一个低频感抗弧组成,且低频感抗成分随浸泡时间延长而减弱并消失;一旦发生剥蚀,其电化学阻抗谱即由一个高频和一个低频两个容抗弧组成。
3.
Current research status of pitting corrosion,intergranular corrosion,stress-corrosion cracking(SCC) and exfoliation corrosion of Al-Li alloys are reviewed in this paper.
综述了铝 -锂合金孔蚀、晶间腐蚀、应力腐蚀断裂 (SCC)及剥蚀的研究现状 ,阐述了加工状态、热处理、显微组织及腐蚀介质对一些铝 -锂合金孔蚀及晶间腐蚀行为与SCC敏感性的影响及其影响机制 。
补充资料:剥露
1.犹揭露。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条