1) family commitment
缓冲变量
2) buffer-related variable
缓冲区相关变量
3) varying load buffer
变载缓冲
4) buffering capacity
缓冲容量
1.
In order to provide theoretical reference to the burl's directional cultivation and utilization research was done on Populus tomentosa,Salix matsudana and Robinia pseudoacacia,and the pH value,buffering capacity of acid and alkaline,curing time of UF of various species of the normal wood and the burl wood were compared.
为了给瘤材的定向培育和合理加工利用提供科学依据,以自然生长的、带有树瘤的毛白杨、旱柳、洋槐为试验材料,对各树种的正常材和瘤材的pH值、酸碱缓冲容量、与脲醛树脂胶固化时间等指标,进行对比研究。
2.
The effect of mashing regime on wort buffering component and buffering capacity were studied.
研究结果表明,投料温度和蛋白质休止温度对麦汁中可滴定酸、磷酸盐、α-氨基氮及缓冲容量均有不同程度的影响,各实验温度下制得麦汁中缓冲物质含量及缓冲容量均大于对照;通过对A(投料温度)、B(保温时间)、C(蛋白质休止温度)及D(蛋白质休止时间)四因素正交实验结果的数据分析,得出影响可滴定酸、磷酸盐含量、α-氨基氮含量、缓冲容量的主次顺序分别为A>D>B=C、C>A>B>D、A>B>C>D、A>D>B>C,可获得最大缓冲容量的工艺为35℃投料下保温30min,53℃下蛋白质休止90min。
3.
The pH and buffering capacity of the dyed wood were determined to compare with that of the plain wood.
分别用酸性染料与活性染料,对大青杨和桦木单板进行直接染色和NaOH溶液预处理后染色,测量2种染色单板的pH值和缓冲容量,并与未染色单板进行对比。
5) buffer capacity
缓冲容量
1.
The determination of buffer capacity of urea-formaldehyde (UF) resin used in MDF is discussed.
探讨中密度纤维板用脲醛树脂缓冲容量的测定,并分析影响脲醛树脂缓冲容量的因素,脲醛树脂缓冲容量对其固化时间和压制中密度纤维板性能的影响。
2.
The effect of important factors on beer buffer capacity and pH, meanwhile, the optimum proportion of buffer substances at the maximum beer buffer capacity can be determined by means of orthogonal experiment with many targets and analysis of variance for correlation ratio.
通过多指标的正交实验及方差分析 ,确定了影响啤酒缓冲容量和pH值的主要因素以及缓冲容量最大时缓冲组分的最佳比例。
3.
In this paper the buffer capacity of strong acid and strong base solution is clarified in terms of buffer capacity differential equation.
本文从缓冲微分方程式说明强酸、强碱溶液具有缓冲能力，并且比同总浓度的由共轭酸碱对组成的缓冲溶液的缓冲容量大。
6) energy snubber
能量缓冲
1.
Research on the control technique of UPFC propotype with energy snubber using SHE method;
基于能量缓冲的优化消谐UPFC物理模型控制技术的研究
补充资料：变量与变量值
可变的数量标志和所有的统计指标称作变量。变量的数值表现称作
变量值，即标志值或指标值。变量与变量值不能误用。
变量值，即标志值或指标值。变量与变量值不能误用。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条