1) ceramic gas turbine
陶瓷燃气轮机
1.
The present status of art, existing problems and development trends of R & D of ceramic gas turbine and low heat rejection ceramic diesel engine for automotive technology are reviewed.
文章主要介绍了汽车用陶瓷燃气轮机和低散热陶瓷柴油机的研究开发现状、存在问题及今后发展动
2) gas turbine
燃气轮机
1.
Investigation on adjusting frequency and relieving vibration of a gas turbine by flexible support and PSFD;
燃气轮机用弹支多孔油膜阻尼器调频减振的研究
2.
Development of water-based cleaning agent for gas turbine;
燃气轮机水基清洗剂的研制
3.
Experiment & Calculation on Acoustic Performances of inlet Muffler & Bending of Gas Turbine;
燃气轮机进气消声器和进气弯道声学性能实验与计算
3) combustion gas turbine
燃气轮机
1.
Presents the design and repair characteristics of the combustion gas turbine, factors affecting its repair and operating life, as well as how to determine correctly the intervals of its two times of repair in Jianfeng Chemical Fertilizer Plant, to provide with references for the turnaround items and turnaround time for the combustion gas turbine.
介绍了建峰化肥厂燃气轮机的设计维修特点,影响燃气轮机的维修和使用寿命的因素,以及如何正确确定燃气轮机的维修间隔期,为确定燃气轮机的检修内容、检修周期提供参考。
2.
This paper presents the problems existed in the operation control and overhaul of the combustion gas turbine in Zhongyuan Dahua Group Ltd.
论述中原大化集团有限公司投产８ 年来燃气轮机操作控制和设备检修中出现的问题，以及解决的措施。
3.
Presents the principle,process flow and control system of the steam ejector in combustion gas turbine in Hainan Fudao Chemical Industry Co.
主要介绍海南富岛化工有限公司燃气轮机蒸汽喷射系统的原理、流程和控制系统 ,同时也列出了运行效果对比和改进方
4) gas turbines
燃气轮机
1.
Introduction for the revision of national standard 《Noise criteria and sound measurement procedures for aero-derivative gas turbines turnkey installations》(GB/T10491)
国家标准《航空派生型燃气轮机成套设备的噪声值及测量》(GB/T10491)修订宣贯
2.
In this paper, the Modelica was used in gas turbines simulation.
本文把Modelica/Dymola软件应用到燃气轮机的仿真中,编制了双轴燃气轮机的仿真程序,获得了合理的结果。
3.
The paper discusses how to prompt the ability of primary frequency regulation of gas turbines, and puts forward the direct primary frequency regulation and indirect methods which has been testified by the digital simulation on a virtual net.
以实施等T 3运行规律为目标的燃气轮-发电机组控制系统不能适应电网频率调节的任务,使其在电网中的份额受到极大限制;讨论了如何拓展燃气轮机的一次调频能力,提出了直接和间接一次调频方法,并通过一个虚拟小电网的数值仿真实验验证了其有效性。
5) gas-turbine
燃气轮机
1.
Review on Inlet Air Cooling Technology for Gas-turbine;
燃气轮机进气冷却技术浅析
2.
Research on reasonable collocation of triple-generation system with gas-turbine;
燃气轮机热电冷联产系统合理配置研究
3.
To analyze the affection of the gas-turbine operational economy and management in different fuels,improve the system,develop for long time,we advise to add gas-pressed equipment and attain the performance,experience,lessons.
分析使用不同燃料对燃气轮机运行经济性和运行管理的影响,从完善系统、可持续发展的角度出发,提出增设配套天然气增压装置,并在实施后取得相应的成绩和经验教训。
6) gas turbine engine
燃气轮机
1.
Design and simulation of magnetic rotor speed sensor conversion circuit for gas turbine engine
燃气轮机磁电式转速传感器信号转换电路设计与仿真
2.
The mathematic model of gas turbine engine is important for the development of ship power and its control system.
建立燃气轮机数学模型是船舶动力及其控制系统研制的重要手段,建模的关键在于提高精度和收敛速度。
3.
The causes of surge fault of Model MS1002D gas turbine engine compressor are investigated and measures are introduced.
分析了MS1 0 0 2D型燃气轮机压缩机组产生喘振故障的原因 ,介绍了解决喘振故障的措
补充资料：MS6001系列燃气轮机一级空心涡轮叶片
MS6001系列燃气轮机一级空心涡轮叶片
Ms6()()l系列燃气轮机一级空心涡轮叶片 中同科学院金属研究所供稿
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条