1) specific charge
比荷
1.
The data processing program of the Zeeman instrument in our lab is only suitable for the three-layer structure,and the specific charge can be measured only by its π light.
汞原子的谱线系包括单层和三层结构,不仅二者在磁场中的塞曼分裂存在差异,而且对于三层结构的线系,其塞曼分裂也比较丰富,在垂直于磁场方向观察,随偏振片角度不同,可以依次观察到σ线及π线2种成分,但实验室用的塞曼效应仪所附带的数据处理程序只适用于三层结构线系,利用π线实现比荷测量。
2) specific charge
荷质比，比电荷，比荷
3) charge-to-mass ratio
荷质比
1.
The influences of the charged voltage, spraying water pressure and electrical conductivity of the droplets on the charge-to-mass ratio (CMR) of the drops are also investigated.
研究压力喷雾荷电中两种主要荷电方法——在喷头上施加电压的直接荷电法和在喷头附近安置电晕电极的电晕荷电法的荷电机理;探讨荷电电压、雾化水压和雾化液体电导率等因素对雾滴荷质比的影响;建立了雾滴荷质比的经验公式。
2.
High selectivity and sensitivity in gas detection can be obtained by measuring the charge-to-mass ratio of gas molecules.
该传感器在敏感环境中,可同时获得敏感膜电导率和质量变化,测量被测气体分子的荷质比,具有高灵敏度和高选择性。
3.
The difference of split wave number in the three-layer structural spectral line is half a Lorentz unit,and the corresponding wavelength difference is different and the formulae of charge-to-mass ratio aren t completely identical as well.
单层结构的谱线在稳恒磁场中分裂时,所分裂的波数差为一个洛伦兹单位L,三层结构的谱线其分裂的波数差为1/2个洛伦兹单位,相应的波长差也各不相同,荷质比公式也不完全相同。
4) charge to mass ratio
荷质比
1.
The particle′s SMD,charge to mass ratio,flux density and flue gas desulfurization efficiency were obtained.
在模拟烟气流动情况下对荷电雾化特性及喷雾脱硫进行了试验研究,获得了雾滴索太尔直径、雾滴荷质比、喷雾流量密度及不同荷电电压下的烟气脱硫效率等。
2.
The charge to mass ratio,diameter(SMD),size distributing,spraying range,spraying angle and sediment of the droplets have been gained and the pressure nozzle spray flow field has been measured by PIV.
获得了雾化角、射程、沉积量分布及雾滴荷质比、索太尔(SMD)平均直径和PIV雾化流场图象等信息,并进行了分析。
3.
The droplet size and the charge to mass ratio are measured by developed device of particle charge to mass ratio and reagent of catching fuel droplets.
将静电技术应用于燃油喷雾燃烧 ,目的是研制一种全新的燃油燃烧技术——荷电喷雾燃烧 ;对这一燃烧方式进行冷态荷电喷雾实验研究 ,在实验研究过程中研制了燃油荷电装置、荷质比测定装置和燃油雾滴的捕集液 ,准确地进行了荷质比、雾滴粒径的测量 ;并首次将 PIV技术应用于荷电喷雾的实验研究。
5) load ratio
载荷比
1.
The fatigue crack propagation behavior of the titanium alloy Ti-4Al-2V bearing hydrogen at a concentration of 110 g/g and 280 g/g under different load ratios was investigated.
研究了含氢量为110g/g和280g/g的Ti-4Al-2V钛合金在不同载荷比下的疲劳裂纹扩展行为。
2.
th is normally viewed as a constant under different load ratios.
不同载荷比下的有效应力强度因子范围门槛值△Keff。
3.
In the paper, the author utiliged the Lagrangian Multiplication changed a typical conditional extreme value into unconditional extreme value, then established the distribution of the load ratio about multistage rocket.
本文应用拉格朗日乘子法，将一个典型的条件极值问题化成无条件极值问题，从而确定多级火箭各级的载荷比。
6) unit load
比载荷
1.
The concepts of load,unit load and loading factor are introduced.
介绍机械密封常用的密封面载荷、比载荷和载荷系数。
2.
A corelation curve describing the relationship between the dimensionless contact area and the unit load on the end-faces of GY70 mechanical seal was obtained by numerical calculation.
采用数值计算方法得到了GY70型机械密封摩擦副端面间的量纲1真实接触面积与端面比载荷的关系曲线。
补充资料：比荷
比荷
电子的电荷量和质量的比值，叫做比荷。
电子的比荷为
说明：补充资料仅用于学习参考，请勿用于其它任何用途。