1) induced sensor
诱导传感器
2) conductance sensor
电导传感器
1.
Wigner-Ville analysis of measurement fluctuating signals of conductance sensor in gas/liquid two-phase flow;
气液两相流电导传感器测量波动信号的Wigner-Ville分析
2.
For the water volume fraction measurement of oil-in-water flow,the mathematical model for the forward problem of sensitivity field in the ring-shape four-electrode conductance sensor was analyzed.
针对水为连续相条件下的油水两相流含水率测量问题,首先分析了环形四电极电导传感器敏感场正问题的数学模型。
3.
An embedded real-time microprocessor MC56F8323 is used for sampling two fluid flowing signals of conductance sensor's output, calculating cross-correlation function of these signals, and finally transferring the flowrate up to the host computer on the ground through RS485.
该仪器使用嵌入式微处理器MC56F8323来实时采集电导传感器输出的2路信号,并对它们进行互相关运算,最后将处理结果通过RS485总线传输至地面上位机。
3) navigation sensor
导航传感器
1.
Wavelet analysis apply to various navigation sensor;
小波分析在各导航传感器中的运用
2.
The theory of wavelet analysis and the multi-resolution analysis method are introduced and then applied to analyze navigation sensor noise in this paper.
根据小波变换的多分辨率分析方法,重点分析小波变换在导航系统中的作用;利用D aubech ies小波函数,采用阈值去噪法,可在低信噪比的情况下较准确地估计导航传感器的原始信号;分别针对多普勒系统和北斗双星定位系统,借助小波变换对其接收信号进行了离线仿真研究。
3.
The work principle of the bionic polarized navigation sensor was analyzed,and then the sensor experiment model and optic calibration instrument were set up.
针对研制仿生导航微传感器的需要,设计并且搭建了偏振导航传感器实验模型。
4) superconductor temperature sensor
超导传感器
1.
The development and application of a new type superconductor temperature sensor was introduced.
介绍一种新型超导传感器的研制方法与标定使用过程 。
5) thermal conductivity sensor
热导传感器
1.
Study on thermal conductivity sensor TCS208F and its signal conditioning circuit
热导传感器TCS208F及其信号调理电路研究
2.
The characteristics and configuration of a new type thermal conductivity sensor for gases were introduced and a signal adjust circuit was designed because of faint output signal.
气体热导传感器是利用被测组分和参考气的热导系数不同而响应的浓度型传感器。
3.
In order to precisely measure the percentage of hydrogen in the hydrogen-cooled generator used in power plants,on constant temperature measurement principle,a detector has been designed based on the thermal conductivity sensor TCS208F,A/D converter AD7710 and the ARM kernel microcontroller LPC2104.
为了能对热电厂氢冷发电机组的氢气纯度进行精确测量,基于热导传感器TCS208F、A/D转换器AD7710及ARM内核的微控制器LPC2104,采用恒温检测的原理设计了一种氢气纯度检测仪。
6) guidance sensor
制导传感器
补充资料：变压器式传感器
利用变压器作用原理把被测位移转换为初、次级线圈互感变化的变磁阻式传感器。它由两个或多个带铁心的线圈构成，初、次级线圈间的互感能随衔铁或两个线圈间的相对移动而改变。当用适当频率的电压激励初级线圈时,次级线圈的输出电压将随互感的改变而变化,从而将被测位移转换为电压输出。这种传感器在使用中常采取两个同名端串接的次级绕组线圈，以差动方式输出，所以又称为差动变压器式传感器。变压器式传感器的特点与电感式传感器相同，有时亦称电感式传感器。但变压器式传感器在设计上具有更大的灵活性，应用更为广泛。旋转变压器、感应同步器、自整角机都属于变压器式传感器。变压器式传感器主要用于测量位移和能转换成位移量的力、张力、压力、压差、加速度、应变、流量、厚度、比重、转矩等参量。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条