说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 可测性测度
1)  Testability measure
可测性测度
2)  measurability
可测度性
3)  possibility measure
可能性测度
1.
Given a fuzzy measurable space(X,)and a possibility measure on (X,), we can extent the possibility measure and fuzzy integral to P(X) and F(X) respectively by using the rough sets theory.
给定模糊可测空间(X, )及(X, )上的可能性测度,通过应用粗集理论,将可能性测度 和模糊糊积分分别扩充至P(X)和F(X)上,从而引入粗可能性测度的概念。
2.
Based on the interpretation of possibility measure based on rough set, we give an conversion algorithm of fuzzy set and rough set, thus establish a connection between these two non-classical set.
在可能性测度的粗糙集解释基础上 ,给出了模糊集与粗糙集的一个转化算法 ,从而建立了两种非经典集合之间的关系 。
3.
This paper is intended to generalize the one dimensional possibility measure totwo dimension by iritroducing two dimensional possibility distribution function.
本文通过引入二维可能性分布函数的概念,将可能性测度推广到二维的情形。
4)  reliability measure
可靠性测度
1.
According to the ratio of signal to noise, the consistent reliability measure of each sensor is defined.
该方法首先视各传感器的测量值为模糊集合,利用模糊集合中的最大最小贴近度来度量不同传感器测量值之间的相近程度,其次给出了不同时刻各传感器的一致性测度,然后基于信噪比定义了一致可靠性测度,最后利用一致可靠性测度得到传感器数据的融合公式。
2.
The consistency measure is given using spacial information and the reliability measure is given using temporal information.
利用多传感器状态估计向量 (或测量值 )的标称化差定义了相似度和相似度矩阵 ,用空间信息形成一致性测度 ,用时间信息形成可靠性测度 ,最终形成了多传感器的组合及加权 ,并进行时空融合 。
5)  testability measurement
可测性度量
1.
The testability measurement is the basic theory of testability design.
针对数字电路的可测性度量,提出了基于SCOAP测度的数字电路故障可测性度量方法。
6)  credibility measure
可信性测度
1.
Study on a model of fuzzy comprehensive evaluation based on credibility measure;
基于可信性测度的一种模糊综合评价模型研究
2.
The flexible job-shop scheduling problem with fuzzy operational duration is introduced in this paper firstly,then the credibility measure,the expected value operator,possibility theory and corresponding concepts are described,after that,an improved flexible job-shop scheduling model based on credibility measure is given to deal with fuzzy scheduling problems.
描述了存在模糊加工时间的柔性工作车队调度问题,阐述了可信性测度、期望值算子和可能性理论等相关概念,给出了以遗传算法为框架的基于可信性测度的柔性工作车间调度模型,最后通过实例验证了模型的可行性和有效性。
3.
Aim at the demand of LR-fuzzy lead time,a continuous review inventory model with variable lead time and service level restriction was established,and the optimal order quantity and lead time were derived by using the theory of credibility measure.
针对LR型模糊提前期需求问题,建立了连续盘点库存策略中提前期为可控变量且具有服务水平约束的库存模型,并运用可信性测度理论对模型进行反模糊化求解。
补充资料:连续性与非连续性(见间断性与不间断性)


连续性与非连续性(见间断性与不间断性)
continuity and discontinuity

11an父ux泊g四f“山。麻以角g、.连续性与非连续性(c。nt,n琳t:nuity一)_见间断性与不间断性。and diseo红ti-
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条