1) Thin current layer model
薄电流层模型
2) charge sheet model
薄层电荷模型
3) thin film model
薄层模型
1.
By using the thin film model,which is based on the brick wall method,the entropy of the Dirac field in a general spherically symmetric and charged evaporating black hole is calculated.
采用薄层模型brick wall方法 ,计算了一般球对称带电蒸发黑洞Dirac场的熵 ,通过适当选择时间依赖的截断因子 ,仍可得出黑洞熵与视界面积成正比的结
2.
Using the thin film model which is based on the brick-wall method, we have calculated the entropy of Dirac field on event horizon and on unit area of Rindler horizon to a straightly accelerating black hole.
采用薄层模型brick wall方法 ,计算出了直线加速动态黑洞视界面上Dirac场的熵以及Rindler视界面上Dirac场的熵密度 ,通过适当选择时间依赖的截断因子ε和薄层厚度δ ,仍可得出熵与面积成正比的结
3.
By means of thin film model, the entropy density at every point of the event horizon is calculated first, then the total entropy is obtained through integration.
前不久我们在 ｔＨｏｏｆｔ砖墙模型的基础上提出薄层模型 ,解决了动态球对称黑洞熵的计算问题[1 2 ] 。
4) thick and thin layer models
厚层和薄层模型
5) laminar flow model
层流模型
1.
For one feed tip, the laminar flow model should be applied and the simulation results are in agreement very well with the results of the water model of this feed tip.
针对在常规铸轧条件下结构型式完全不同的2种铸嘴,根据实际工况,分别应用层流模型和低雷诺数的k-ε湍流模型,用商业软件CFX(version4。
2.
When the simulation is conducted using laminar flow model,the flow field in settling tank can not be obtained.
平流式沉淀池内水流的雷诺数>3 000(为紊流),当利用传统的层流模型进行模拟时不能准确获得沉淀池内的流速场分布,若采用特征涡粘性雷诺数或密布网格,则可以扩展层流模型模拟沉淀池内物理量的适用性。
6) Laminar model
层流模型
1.
Distribution of the disturbance and its non-line term and relation of the phase were also studied with laminar model in this paper.
利用层流模型,把空间周期性边界条件作为某种扰动,研究了扰动及其非线性项的分布以及相位问的关系,得到了一些有益的结果。
补充资料：标准冲击电流波形(见冲击电流发生器)
标准冲击电流波形(见冲击电流发生器)
standard impulse current wave form
blaozhun ehonglld}0n4一u box]ng标准冲击电流波形(standard impulse currentwave form)见冲击电流发生器。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条