This paper gives an introduction to a new method for developing automation generation technique of the interconnection diagram for electronic products, which is realized by reading and writing the mechanism-mute diagram on the basis of the circuit link information in circuit schematic plotted by Protel.

Research on Teaching Methods of Mechanical Drawing lesson;

About the Mechanical Drawing Teaching Based on 3D Design;

How to Improve Students,learning Interest in Teaching of Mechanical Drawing;

According to the characteristics of the mechanical drafting course,the reform and investigation of teaching content and teaching method etc.

In the courses of mechanical drafting teaching and the Auto CAD Software, coping with the correct relations between the contents of two courses is the requirement to guarantee the teaching efficiency.

This paper describes a reform in the teaching of the course in mechanical drafting in the areas of course structure, teaching materials and teaching methods.

The application of software Pro/Engineer in the teaching reform of the course of《machine drawing》;

Machine Drawing Course in Higher Vocational Education and the Study of Its Teaching Reformation;

Study and Discussion on Creativeness Teaching Method of Machine Drawing at Vocational and Technical College

Research and Practice on Reforming the Curriculum of "Mechanical Cartography" in Higher Vocational Colleges;

Development and Application of Mechanical Cartography Virtual Model Depot;

This paper discusses the training of innovation idea in learning mechanical cartography.