1) quake
[英][kweɪk] [美][kwek]
弹限
2) elastic limit
弹性极限
1.
Using elastic solution of thick wall cylinder, it is analyzed that the optimum design on three-layers assembled cavity die of cold extrusion under the elastic limit stress.
应用厚壁圆筒的弹性解 ,分析了冷挤压三层组合凹模具有最大弹性极限时的优化设计 ,推导了三层组合凹模的最大承压、各层分界面半径和分界面过盈量的优化设计计算公式。
2.
Based on the analysis of the vertical sealing mechanism of fault and its influncing factors, this paper puts forward the conception of favounable depth forming the vertical sealing of fault, establishes the method determining upper and lower limit depth by the equalization of the vertical pressure of faulted zone to elastic limit and intensive limit of mudstone.
在深入分析断层垂向封闭机理及其影响因素的基础上 ,提出了断层垂向封闭形成有利深度的概念 ,并建立了利用作用于断裂带正压力与泥岩弹性极限和强度极限相等来确定形成断层垂向封闭上、下限深度的方法 。
3.
The side-rolling resistant torsion bar made of this steel exhibits high fatigue life span and elastic limit.
采用该材料制造的抗侧滚扭杆具有高的疲劳寿命和高的弹性极限。
3) ammunition limited
弹药受限
4) limit spring
限位弹簧
1.
For this reason a limit spring hanger, which has both vibration-isolation effect of the spring and maintained the property of original rigid hanger, had been designed.
对此 ,设计了既有弹簧隔振效果又能保持原有刚性吊架特性的限位弹簧支吊架。
5) ballistic limit
弹道极限
1.
Ballistic limit parameter tests of the Whipple shield;
Whipple防护屏弹道极限参数试验
2.
Numerical simulation combined with experiment validation was adopted to investigate the ballistic limit of aluminum 5A06 single wall plate,5 mm in thickness,subjected to normal impac.
采用数值仿真并结合试验验证的方法,对5mm厚5A06铝合金单层板承受2A12铝合金球形弹丸正撞击下的弹道极限进行了研究。
3.
On the basis of two-phase engineering model for ideal elastic-plastic material,the analytical formula of the critical semi-angle of the projectile nose and the corresponding ballistic limit velocity for the train-hardening material target were gained.
研究了刚性锥头弹垂直贯穿金属靶板扩孔冲塞型穿孔模式,在理想弹塑性材料两阶段工程模型的基础上,考虑靶板为硬化材料,得到扩孔冲塞型穿孔弹头临界半锥角及相应的弹道极限。
6) elastic strength
弹限强度
补充资料：半硬壳式弹体(见弹道导弹弹体)
半硬壳式弹体(见弹道导弹弹体)
semi-hard-shelled missile body
bQn yingkeshi dan桩半硬壳式弹体(semi一hard一shelled、ssilebody)见弹道导弹弹体。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条