1) critical acceleration of liquefaction
液化临界加速度
2) critical acceleration
临界加速度
1.
The critical acceleration for the control rod not to move up or down abnormally was determined using the m.
通过对计算结果进行分析,得出不同温度、流量下水力驱动控制棒系统不出现异常提棒现象的临界加速度。
2.
Based on the Newmark analysis,a method is introduced to deduce critical acceleration with the data of strong motion records and landslides.
根据Newmark方法提出一种在已知强震记录和滑坡数据的情况下,推导斜坡临界加速度的方法。
3) critical pressure increase rate
临界加压速度
1.
It is shown that the wall width of castings has obvious effect on critical pressure increase rate and critical filling rate, the thinner the wall width of castings is, the bigger the critical pressure increase rate and critical filling rate .
实验结果表明 ,铸件壁厚对临界加压速度和临界充型速度影响很大 ,铸件壁越薄 ,临界加压速度和临界充型速度也越大 ;内浇口形状和数量对充型平稳性影响不显著。
4) Critical acceleration factor
临界地震加速度
5) critical liquefaction intensity
液化临界烈度
6) Minimum fluidization velocity
临界流化速度
1.
The fluidization behavior of glass beads is investigated in superheated steam fluidized bed with a cone shape and the bottom diameter of 120mm for research about the influences of operating temperature and pressure on minimum fluidization velocity(um f).
在底部直径为120 mm的锥型流化床中,以玻璃珠为流化颗粒,过热蒸汽为流化介质,研究了固体颗粒在过热蒸汽流化床中的流化特性,考察了操作温度和压力对临界流化速度(umf)的影响。
2.
The influences of temperature and particle size on the minimum fluidization velocity and the influence of temperature on the particle size distribution were observed by pressure-drop method according to the abnormal fluidization of bimodal polyethylene sticky particles in the combined process of loop reactor and fluidized bed.
针对环管和流化床串联的组合工艺中双峰聚乙烯黏性颗粒流化状况不佳的现状,利用压差法系统考察了温度和粒径对临界流化速度的影响,以及温度对粒径分布的影响。
补充资料：法向加速度
（见加速度）。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条