1) interference stress distribution
干涉螺接应力
1.
A new experimental method measuring interference stress distribution near holes was presented.
本文提出一种测量孔边干涉螺接应力分布的新实验方法,用激光散斑干涉技术测量出由干涉螺接应力形成的孔周位移场分布,进而确定孔这应力分布,在保证测量精度同时,该方法体现出了简单,实用,有效等优点。
2) interference stress
干涉应力
1.
An experimental study was conducted to measure residual stress distribution around cold-expanded fastener holes and interference stress distribution near interference fit fastener holes.
本文就冷胀孔周残余应力分布的测量技术和干涉螺接孔周干涉应力分布的测量技术进行了实验研究。
3) interference prestressing
干涉预应力
4) stress-strength interference
应力-强度干涉
1.
Common cause failure as an important mode of dependent failure was considered and the reliability models of systems with common cause failure were built with the stress-strength interference model in system-level directly.
考虑共因失效相关性,在系统层运用应力-强度干涉模型建立了共因失效系统可靠性模型。
2.
With the conditional reliability introduced in and without the assumption that there is independent failure mode of gear,a reliability calculation model of gear with multiple failure modes is developed using the stress-strength interference model.
通过引入条件可靠度,在不作失效独立假设的前提下,运用应力-强度干涉模型建立了具有多种失效模式的齿轮可靠度计算模型。
3.
The stress-strength interference (SSI)model is a basic tool for structural reliabilityanalysis.
应力-强度干涉(Stress-Strength Interference，SSI)模型是结构可靠性分析的基本工具。
5) interference prestress release
干涉预应力释放
1.
We discuss the 3D cracks around cold-expanded holes and simulate their interference prestress release using the engineering software of ANSYS to study the effect of the interference prestress release on stress intensity factors(SIFs) at crack tips.
文中将干涉预应力考虑为内部载荷,分别对不同裂纹长度下的含裂纹体进行挤压,在不同的挤压状态下直接求解应力强度因子,以此等效地模拟裂纹扩展过程中干涉预应力释放的应力强度因子求解。
6) stress strength interference
应力强度干涉法
补充资料：接应
①配合自己一方的人行动：你们先冲上去，二排随后～。②接济；供应：粮草～不上。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条