说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 短路故障点
1)  Short-circuit hitch
短路故障点
2)  short circuit malfunction
短路故障
1.
Automatic diagnosis system for monitoring short circuit malfunction of electric net in oilfield;
油田电网短路故障诊断系统
3)  short-circuit fault
短路故障
1.
Research on overvoltage output of SPWM inverter after short-circuit fault disappears in a short time;
短路故障消除后SPWM逆变器输出过压问题研究
2.
The mathematical model for the short-circuit fault analysis and the realization of the program is discussed.
阐述了电力系统短路电流计算的原理,讨论了电力系统短路故障分析的数学模型及程序实现方法,并在分析短路电流计算原理的基础上通过可视化软件MATLAB建立了短路故障的模型,实现了其程序编制。
3.
The current signals caused by lightning strike without any fault or with fault and by common short-circuit fault are analyzed,and the characteristics are obtained: firstly,energy distributions of all frequency bands are differ.
在现有行波测距装置的基础上,提出线路受雷击和出现短路故障的识别新方法。
4)  short circuit fault
短路故障
1.
The performance of STATCOM using optimal controller at short circuit fault and load step is compared with its performance when PI controller is adopted,and its affection to the voltage and reactive power is analyzed through simulation.
通过数字仿真,对比分析了STATCOM分别采用最优控制与传统PI控制时,在电网发生短路故障和负载阶跃工况下的性能,着重分析了其对电压和无功的影响。
2.
With increase of the capacity of power system,transformer faults caused by short circuit fault occurred now and then.
220kV变压器通常采用部分接地方式,因系统容量增加,短路故障引发变压器故障时有发生。
5)  short circuit
短路故障
1.
In view of the trouble that short circuit occurred frequently in 110kV transfer substation,the method that uses change of 10kV side current of the main transfer substation to calculate the current of short circuit and infer accurate trouble point position and remove the trouble rapidly has been found out in practice to recover power supply.
针对天铁110kV变电站频繁发生短路故障问题,实践中摸索出根据主变10kV侧电流的变化,计算短路故障电流,准确推断故障点位置的方法,迅速排除故障恢复正常供电。
2.
On MATLAB simulation flat,after introducing the basic components,we can get ideal simulation results by designing,simulating and analyzing short circuit fault of a simple power system transmission line.
SimPowerSystems是专门为电力系统设计的仿真分析软件,在对其基本元件进行介绍后,在仿真平台上,通过对一个简单的电力系统输电线路的短路故障进行设计、仿真、分析,得到了理想的仿真效果。
6)  short fault
短路故障
1.
Combining the switch-level model of RTD circuits and the basic principle of open faults and short faults, the control signals were added to generate the test benches by utilizing the control signals reasonably to achieve th.
该方案基于RTD电路开关级模型,针对电路基本的开路、短路故障合理增加控制端,利用控制端信号设计测试向量,使电路达到完全可测的目的。
2.
In this paper, the fundamentals of developing the overhead-contact short fault detector is introduced.
介绍了接触网短路故障探测仪的研制原理,提出了用电抗量计算短路点位置的新方法,并用该装置进行实地试验,计算结果误差控制在400m以内。
3.
This paper is emphasis on the study of circulation control mode and short fault of ITER poloidal field power supply system.
论文的主要的工作是分析极向场主整流器均流、环流控制问题以及电源短路故障。
补充资料:闭式单点、双点压力机
代码:00413
设备名称:闭式单点、双点压力机
型号规格:公称力≥800kN
计量单位:台
主要参数内容
国际先进国内先进国内一般国内落后评定方法及说明
(一)加工精度
    参照GB10924-89、GB10933-89、JB5200-91
1、滑块下平面对工作台上平面的平行度(mm)
30%精度储备20%精度储备达到规定值大于规定值 
0.02+0.10/100×滑块下平面的被测长度
     
2、滑块行程对工作台上平面的垂直度
30%精度储备20%精度储备达到规定值大于规定值 
0.05+0.02/100×滑块行程长度
     
(二)结构性能
     
1、离合器、制动器接通率,当滑块行程次数≤16次/分时为70%,≤25次/分时为60%,≤45次/分时为50%
大于规定值10%大于规定值达到规定值达不到规定值 
2、液压超负荷保险装置、微调装置、吨位指示器
全部具有全部具有部分具有没有 
(三)噪声dB(A)
     
1、公称力≤400kN
≤85≤87≤88>88 
2、公称力>400kN
≤87≤88≤90>90 
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条