A method for extracting chip S-parameters was introduced based on the TRL (thru-reflect-line).

A Dual Six-port Network Analyzer Used as S-Parameters Standard at 26.5~40 GHz;

Methods to Calculate S-parameters at Any Port of Waveguide Using the Calculated Electric Fields Based on FDTD Software;

Overview on Large Signal Analysis and Testing Technology for RF Network Going Beyond S-parameters;

Design method of microwave power amplifier with small-signal S parameters;

The Statistics Constraint of Characteristic Phase for Lossy Networks S Parameters;

A Study on S Parameters of RF Microstrip Circuits on Si;

Error and error correction in S-parameter measurement;

Measurement Calibration for the S-parameter Testing Set;

A 2-port S-parameter measurement with the center-tap grounded is used to extract the equivalent resistance,inductance,and Q-factor (RLQ).

In this simulation,the satisfied results are obtained with the S parameter simulator and harmonic balance simulator.

Si(100) crystal implanted by 5×10 16 cm -2 , 140keV He + was probed by slow positron beam, and defect distribution along depth was obtained from the relation between S parameter and positron incidence energy.

The composition and principle of T/R module automatic test system for active phased array radar are described,including the principle of pulse S parameter automatic test sub-system and the integration technology of non-S parameter automatic test sub-system.