说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 透射增益
1)  transmittance gain
透射增益
1.
The investigation results show that a large transmittance gain appears at the photonic band edges if an imaginary part of dielectric constant defect is added in the photonic crystals.
结果表明,当在光子晶体加入复介电常量的缺陷层后,在靠近光子带隙边缘,出现了较强的透射峰增益;随着缺陷层复介电常量的实部和虚部的增加,透射增益先增加后减少,中间存在一极值点,但缺陷膜的位置和高度不受复介电常量的实部和虚部的影响。
2.
The large transmittance gains appear at transmittance peaks if the imaginary part of dielectric layer\'s dielectric constant is negative.
随着复介电常量的虚部的增加,两透射增益先增加后减少,中间存在一极值点。
3.
The large transmittance gains appear at transmittance peaks if the imaginary part of dielectric layer\'s dielectric constant is negative,and the transmittance gains decrease in exponent with the increasing of wavelength when the absolute of the imaginary of dielectric constant is lesser.
随着复介电常量的虚部绝对值的增加,各透射增益先增加后减少,中间存在一极值点。
2)  gain transparency
增益透明
3)  transmission enhancement
透射增强
1.
Numerical simulation has been performed on the optical transmission enhancement of a metallic film with a two dimensional subwavelength hole array.
对金属薄膜上的二维亚波长小孔阵列的光透射增强现象进行了数值模拟 ,结果显示不仅实际金属薄膜上的小孔阵列结构具有透射增强效应 ,理想导体薄膜的相同结构也具有透射增强效应 ,但没有实际金属薄膜的增强明显 。
4)  enhanced transmission
增强透射
1.
Optical wave transmission through a subwavelength slit grooved with cavity in internal wall is investigated in a thick metallic plate by two-dimensional finite-difference time-domain method,and enhanced transmissions are found at some wavelengths in transmission spectra.
利用时域有限差分法模拟了厚金属层上单一亚波长狭缝内壁刻有一微型腔结构光波传输,结果发现在特定波长发生异常的增强透射。
5)  radiation sensitizing
放射增益
1.
Objective To study the radiation sensitizing effect of hydroxycampotothecin(HCPT) on human cervical carcinoma(HeLa)cell and the influencing factors(schedule,concentration and timing).
目的研究羟基喜树碱(HCPT)对人宫颈癌HeLa细胞系的放射增益作用以及给药时序、药物浓度和作用时间对放射增益作用的影响。
6)  reflection gain
反射增益
补充资料:布里斯托尔相对增益
分子式:
CAS号:

性质:在一个装置上设置多个控制系统时,系统间会存在相互耦合。但其关联程度可用布里斯托尔相对增益λij来衡量。相对增益λij的定义是在其他控制系统均为开环时,第j个控制变量Uj对第i个输出变量Yi通道的放大系数(增益)与该通道在其他控制系统均为闭环时放大系数(增益)之比,称为相对增益。由于是布里斯托尔提出的,所以又称布里斯托尔相对增益。当系统间无耦合时,一个控制回路是处于开环或闭环状态,对另一个控制回路是不会起影响的,故λij=1。但在系统间存在耦合时,情况就不同了,耦合越严重,一个控制回路处于开环或闭环,对其他控制回路影响就越大,λij偏离l就越远。因此,相对增益λij可用来衡量控制系统间关联的程度。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条