1) resistance factor
阻力因数
1.
Effect of shearing polymer on resistance factors and residual resistance factors;
剪切聚合物对阻力因数和残余阻力因数的影响
2.
For two typical inlet ports, the simulation pictures the relationships of local resistance factor with the opening of inlet port and the initial condition.
用任意拉格朗日 -欧拉 (AL E)计算方法对发动机进气门附近的气体流动进行数值模拟研究 ;针对两种典型结构的进气门 ,在对气体流动进行数值模拟及对阻尼特性进行分析的基础上 ,分别给出局部阻力因数与气门开度及初始条件的关系曲线 。
2) friction resistance factor
摩擦阻力因数
1.
Solving process of friction resistance factor by Celebrook formula and selection of initial value are discussed, and programming calculation of branch courtyard gas pipeline supplying less than two thousand householder is studied.
探讨了柯列勃洛克公式摩擦阻力因数的解法和初值的选取,研究了2000户以下庭院枝状燃气管道的编程计算。
3) residual resistance factor
残余阻力因数
1.
Effect of shearing polymer on resistance factors and residual resistance factors;
剪切聚合物对阻力因数和残余阻力因数的影响
4) Darcy friction factor
达西阻力因数
5) resistance augment factor
阻力增额因数
6) resistance factor
阻力因子
1.
The results of plugging off experiment indicate that YFP-2 foam agent can plug efficiently because its resistance factor is larger than 2.
封堵实验结果表明,阻力因子大于2。
2.
The resistance factor of gas and liquid commingled injection grows with the injection rates rising while that of gas and liquid alternative injection wavily rises with the injection rates rising,however both the methods ca.
封堵调剖实验表明,泡沫复合驱具有优良的封堵调剖能力,其封堵能力随渗透率增加而增大;气液共注时,阻力因子随注入量增加而持续增大,交替式注入时,阻力因子随注入量的增加波动上升,但随着注入量不断增加,两种方式均能产生较好的封堵效果;低气液比交替注入时,封堵作用表现缓慢;大段塞交替注入时,封堵效果相对较弱。
3.
The results showed that the resistance factor of FPJ surfactant achieved 17.
结果表明,表面活性剂FPJ的阻力因子达到17。
补充资料：肺循环阻力(或全肺阻力)
肺循环阻力(或全肺阻力)
pulmonary circulation resistance
血液在肺部血管内流动时和血管壁之间的摩擦力和血液内部的摩擦阻力。肺动脉管壁较薄，分支短而管径大，故肺动脉的可扩性较大，对血流的阻力很小，仅0.12PRU(外周阻力单位)。肺循环动脉部分总的阻力和静脉部分总的阻力相等，故血液流动时在动脉部分的压力降落和静脉部分的压力降落相等。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条