说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 集中算子
1)  concentrate operator
集中算子
1.
As FKCN algorithm s convergence rate is too slow,we insert concentrate operator and dilation operator into FKCN algorithm to accelerate convergence rate.
针对FKCN算法收敛速度较慢的缺点,通过引入集中算子和扩张算子,在保证聚类准确度提高的情况下,还较大的加速了算法的收敛速度。
2)  Centralized Settlement
集中结算
1.
Comprehensively Implementing the Centralized Settlement of Major Clients Transportation Charges and Continuously Deepening the Carry-out of Major Client Strategy;
实行大客户运费集中结算 深化铁路大客户战略实施
3)  centralized accounting
集中核算
1.
Financial centralized accounting in highway construction enterprises;
公路施工企业中的财务集中核算
2.
The functions of financial department of the unit concerned have been weakened after implementing centralized accounting.
本文从实行会计集中核算后导致本单位财务部门职能的弱化,提出在实行会计集中核算后单位财务部门职责重心应转移到参与单位经营管理上来,进一步强化财务管理职能。
3.
After centralized accounting,to some extent,the new accounting model breaks the old patterns of the financial accounting management system.
会计集中核算后,这一新的会计核算模式在一定程度上打破了传统的财务会计工作管理体系,再由于制度建设的滞后、认识上的差异等方面原因,导致财务监督工作出现了一些新的问题丞待解决。
4)  centralized computing
集中运算
1.
Furthermore, in order to overcome the disadvantage of the centralized computing of RPE learning algorithm, a parallel structure algorithm is derived.
首先,引入递推预报误差(RPE)学习算法,并且证明了其稳定性;进一步地,为了克服RPE算法集中运算的不足,设计完整的并行结构算法。
5)  aggregation operators
集结算子
1.
Propose an ex-ante evaluation method of Aviation Maintenance Information System(AMIS) incorporating Goal Programming(GP),Analytic Network Process(ANP) and aggregation operators.
融合目标规划、网络分析法和集结算子,提出一种航空维修信息系统的事前评价方法。
2.
Then according to the weight information of the two-tuple linguistic evaluation information,two different aggregation operators were used to aggregate the experts′ preferences.
该方法首先将决策专家给出的语言评价矩阵转化为二元语义,然后根据是否已知与二元语义相对应的权重信息,分别给出了两种不同的集结算子来对各决策专家给出的偏好信息进行群集结,在此基础上对方案进行排序,从而得到最终的群决策结果,最后给出了一个算例。
6)  operator sets
算子集
1.
The definition of software architecture operator sets are discussed;and then the properties for simple operator set A_(simple)and complex operator sets A_(complex) are drived.
基于语法树并以数据类型为对象而构造的描述软件体系结构的算子,进一步深入地研究描述软件体系结构的算子集的定义及其相关概念,并对算子集中的简单算子集Asimple和复合算子集Acomplex的性质进行了推导,从而得出了一些重要的推论和定理。
补充资料:凹算子与凸算子


凹算子与凸算子
concave and convex operators

凹算子与凸算子「阴~皿d阴vex.耳阳.勿韶;.留叮.肠疽“‘.小啊j阅雌口叹甲司 半序空间中的非线性算子,类似于一个实变量的凹函数与凸函数. 一个Banach空间中的在某个锥K上是正的非线性算子A,称为凹的(concave)(更确切地,在K上u。凹的),如果 l)对任何的非零元x任K,下面的不等式成立: a(x)u。(Ax续斑x)u。,这里u。是K的某个固定的非零元,以x)与口(x)是正的纯量函数; 2)对每个使得 at(x)u。续x《月1(x)u。,al,月l>0,成立的x‘K,下面的关系成立二 A(tx))(l+,(x,t))tA(x),00. 类似地,一个算子A称为今单(~ex)(更确切地,在K上“。凸的),如果条件l)与2)满足,但不等式(*)用反向不等号代替,并且函数粉(x,t)<0. 一个典型的例子是yP‘KOH积分算子 通rx‘t、1二f天(t.:,x(s))山, G它的凹性与凸性分别由纯量函数介(t,s,。)关于变量u的凹性与凸性所确定.一个算子的凹性意味着它仅仅包含“弱”的非线性—随着锥中的元素的范数增加,算子的值“慢慢地”增加.一般说来,一个算子的凸性意味着,它包含“强”的非线性.由于这个理由,包含凹算子的方程在许多方面不同于包含凸算子的方程;前者的性质类似于相应的纯量方程,而不同于后者,后者关于正解的唯一性定理是不成立的.
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条