1) asymmetrical multi spots initiation
偏心多点起爆
1.
The regularity of fragments dispersion of the warhead under asymmetrical multi spots initiation is studied.
研究战斗部偏心多点起爆条件下破片径向飞散规律 。
2) asymmetrical initiation
偏心起爆
1.
The characteristics of detonation wave in dual explosive under asymmetrical initiation was studied.
为研究复合装药在偏心起爆条件下的爆轰波特性,采用转镜式高速相机狭缝扫描技术对装药表面的爆轰波形传播过程进行测量,得到爆轰波在狭缝位置的扫描曲线、时空坐标以及爆轰波阵面分布图。
3) multi-point initiation
多点起爆
1.
The test set of the Explosively Formed Projectile (EFP) with star shaped tail was designed with a multi-point initiation.
采用多点起爆方式,设计了带尾翼翻转型爆炸成形弹丸(EFP)试验装置。
4) Multiple-point simultaneous initiation
多点同步起爆
5) multi-point explosive circuit
多点起爆网络
1.
According to the design of a synchronous multi-point explosive circuit and the requirements to synchronization,a "one-in-four-out" explosive circuit was designed and a new loading technique—the exact press loading technique was used and tested.
结合同步多点起爆网络的设计方法及其对爆轰波输出同步性的要求,设计了“一入四出”偏心式圆周线同步起爆网络,提出并试验了一种新的网络装药技术—精密压装装药技术,对其爆轰波输出同步性进行了理论分析,并用探针法测定了其爆轰波输出同步性。
6) selectable initiation shaped charge
多点起爆技术
补充资料：在AutoCAD中偏心圆锥与偏心圆台实体的画法
现在要画一个偏心圆锥,底面在WCS的XY平面上,圆心(0,0,0),半径100,顶点(300,0,400)在ZX平面上.
1)连接PA,PB. A(-100,0,0) B(100,0,0)
图1
在当前坐标下:
2)延长PA到C,使PA=CA;延长PB到D,使PB=DB;
3)连接CD;
4)以CD为直径画圆;
5)用XLINE命令中的二等分选项作角CPD的角平分线PO,交CD于O;
6)过O作CD的垂线,交圆于E,F;
图2
7)用三点UCS命令,取三点为:O,P,C;
8)过点O作PO的垂线GO,交PC于G;
图3
9)再次用三点UCS命令,取三点为O,F,G;
10)现在就可以画椭圆锥了!
cone-e-c-捕捉O点-捕捉F点-捕捉G点-a-捕捉P点;
图4
11)回到WCS,剖切椭圆锥
SL-选择椭圆锥-回车-XY-回车-捕捉P点.
12)删除辅助线条.
图5
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条