1) processing rubbe
胶园凝胶
2) rubber plantation
胶园
1.
The distribution of leaf nutrient in part of east farm of Hainan province with the kind of PR107 and RRIM600 rubber tree was studied,the result indicated that there was special difference in the kinds of high,secondary and low yield rubber plantation.
对海南省东部部分农场PR107和RRIM600不同产量水平的成龄胶园叶片养分分别进行了研究,结果表明,两个品种的高、中、低产胶园叶片养分状况都存有明显差异,PR107品种高产胶园的全氮和全磷显著高于中、低产胶园;RRIM600不同产量水平的胶园中全钾和钙存在显著差异。
3) Sol-Gel
溶胶-凝胶
1.
Effect of pyrolysis atmosphere on properties of BLT ferroelectric films deposited by sol-gel method;
热分解气氛对溶胶-凝胶法制备BLT铁电薄膜性能的影响
2.
Chemistry Mechanism Discussion of Preparing HAP with Sol-gel Method;
溶胶-凝胶法制备羟基磷灰石粉体化学机理分析
3.
Synthesis of the blue long afterglow phosphor Sr_2MgSi_2O_7:Eu,Dy by sol-gel method and its luminescent properties;
溶胶-凝胶法合成蓝色长余辉材料Sr_2MgSi_2O_7:Eu,Dy及其发光特性
4) sol–gel
溶胶–凝胶
1.
Titania nanoparticles were then filled into the gaps among the nanorods through an infiltration sol–gel procedure to form a composite titania film with an ordered nanostructure.
用双氧水低温氧化金属钛片的方法制备了TiO2纳米棒阵列,并以该阵列为基体,用浸渍渗透溶胶–凝胶技术制备了TiO2纳米颗粒嵌入TiO2纳米棒阵列基体的复合结构薄膜。
5) sol-gel process
溶胶-凝胶
1.
Preparation of high temperature insulation paint by Sol-Gel process;
溶胶-凝胶法制备耐高温绝缘涂料
2.
Nanometer scale TiO2 film was prepared on glass substrate with film thickness less than 100 nm,crystal size in the range of 10~30 nm by sol-gel process combining with spin-coating technology.
以玻璃为基底,采用溶胶-凝胶法,利用旋涂技术在玻璃表面制备了膜厚小于100 nm,粒径在10~30 nm之间的纳米TiO2薄膜;利用XRD,AFM系统研究了煅烧温度及膜厚对薄膜亲水性的影响。
3.
The stable ZrO2 sol is prepared by sol-gel process with Zr(O-Bu)4 as the starting materials in this paper .
以锆酸丁酯为前驱体,采用溶胶-凝胶工艺,制备了性能稳定的ZrO_2溶胶,通过在其中添加有机粘合剂PVP和旋涂镀膜法分别制得了ZrO2薄膜和ZrO2-PVP复合薄膜。
6) solgel
['sɔldʒel]
溶胶凝胶
1.
The activity of FCC additives of Zn(Al2O)2 with different ZnO contents were prepared by solgel,and the desulfurization effect of additives in the gasoline was evaluated in a micro reactor.
本研究以A l2O3为载体,采用溶胶凝胶法制备了不同氧化锌质量分数的液体脱硫助剂,在固定床微型反应器上对助剂。
2.
S1200 bioactive glass-ceramics were prepared by sintering the solgel derived 58S bioactive glass at 1 200 ℃, and 58S1200 glass-ceramic showed a higher bending strength and density as compared to 58S glass.
以溶胶凝胶58S生物玻璃为原料在1200℃煅烧制备了玻璃陶瓷块体。
3.
The resorcinolformaldehyde (RF) and nickel hydroxide compound aerogels were synthesized by solgel process and supercritical drying technique using resorcinol, formaldehyde, nickel nitrate and anhydrous sodium carbonate as raw materials.
以间苯二酚、甲醛、碳酸氢钠、硝酸镍为原料,采用溶胶凝胶法和超临界干燥工艺制得间苯二酚甲醛与Ni(OH)2复合气凝胶,对不同pH值和Ni(OH)2含量的复合气凝胶结构进行研究。
补充资料：Sds-聚丙烯酰胺凝胶电泳凝胶电泳
sds-聚丙烯酰胺凝胶电泳（sds-page，sodium dodecyl sulfate-polyacrylamide gel electrohoresis）
在有去污剂十二烷基硫酸钠存在下的聚丙烯酰胺凝胶电泳。sds-page只是按照分子大小分离的，而不是根据分子所带的电荷和大小分离的。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条