1) Half-pipe culture technique
半套管
2) Half shaft bushing
半轴套管
1.
The loose tooling forging of half shaft bushing on the steam-air forging hammer is numerically simulated using FEM software DEFORM3D.
采用商用有限元软件DEFORM3D对半轴套管胎模锻成形过程进行了计算机模拟。
3) axle shaft tube
半轴套管
1.
Numerical simulation of forging and deep extrusion compound process for axle shaft tube;
半轴套管锻造及深孔挤压复合工艺数值模拟
2.
The PLC applied in the hydraulic control system of the forming equipment of axle shaft tube;
PLC在半轴套管成型机液压控制系统中的应用
4) half-pipe jacket
半管夹套
1.
3-D finite element analysis of welding residual stress for half-pipe jacket made of 304 stainless steel;
SS304半管夹套焊接部位残余应力三维有限元模拟
2.
The general problem of half-pipe jacket is the leakage of the welding line induced by crack.
本文利用有限元软件ABAQUS,开发了一个顺次耦合的焊接热应力计算程序,讨论坡口形式、线能量、半管间距等参数的变化对焊接残余应力的影响,得到了半管结构残余应力分布特征,找到了最大焊接残余应力的位置及大小,为半管夹套的安全评定提供参考。
5) half-shaft casing
半轴套管
1.
Parameter determination of three-roller cross-rolling half-shaft casing;
半轴套管三辊滚缩成形工艺参数的确定
6) axle shaft sleeve
半轴套管
1.
Experimental research of forming process for axle shaft sleeve with flange far from big end;
凸缘远离大端的半轴套管成形工艺实验研究
2.
Applying software DEFORM,the forming process has been analyzed for axle shaft sleeve.
应用DEFORM软件对半轴套管成形过程进行数值模拟,分析了金属在成形过程中各种场量的变化,对不同成形方案金属流动情况(或填充性)进行了预测,确定了最优的成形工艺和合理的模具结构。
3.
Aiming at the two structural features of axle shaft sleeve on the basis of analyzing various forming technologies applied in domestic and overseas in recent years,two new hot extrusion forming technology of axle shaft sleeve are worked out.
针对半轴套管的两种结构特点,在分析了国内外近年来所采用的各种成形工艺的基础上,分别开发了用镦粗-反挤压和扩径-正挤压两道复合工序相结合成形分体式半轴套管和用两次复合镦挤的方法成形整体式半轴套管的两种热挤压成形新工艺,通过物理模拟实验证明了成形工艺的可行性、实用性。
补充资料：半…半…
分别用在意义相反的两个词或词素前面，表示相对的两种性质或状态同时存在：～文～白ㄧ～真～假ㄧ～信～疑ㄧ～推～就。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条