1)  airlift bioreactor
气升式发酵体系
1.
The technical conditions of γ-linolenic acid (GLA) production and the efficiency of the GLA production by filamentous fungi fermentation in both the airlift bioreactor and the stirrer bioreactor were studied.
研究了不同生物反应器体系中丝状真菌产生γ-亚麻酸的工艺,结果表明:气升式发酵体系明显优于搅拌式发酵体系,二者γ-亚麻酸含量相差6%。
2)  Airlift
气升
1.
Theoretical Prediction of Liquid Circulation Velocity in inter-Loop Airlift Reactors;
内循环气升式反应器液体循环速度理论预测
2.
Volumetric mass transfer coefficient in external loop airlift membrane reactor;
外循环气升式膜反应器中的体积传质系数
3)  change in temperature
空气升温
1.
Firstly,fire growth coefficient doesn't influence on the change in temperature, but the rate of change in temperature.
大空间建筑火灾空气升温与小室火灾空气升温相差较大 ,用基于场模型的 FDS计算程序模拟多系列火灾场景 ,对影响大空间建筑火灾空气升温参数作定性的分析 ,得出 :(1)火源功率增长系数不影响升温幅度 ,但影响升温速度 ;(2 )火源功率与空气升温具有强相关性 ;(3)当建筑面积≤ 30 0 0 m2 ,建筑面积与空气升温有强相关性 ,当建筑面积 >30 0 0 m2 ,建筑面积对空气升温影响很小 ;(4)建筑空间高度与空气升温有强相关
4)  air lift circulation
气升循环
5)  airlift
气升式
1.
Liquid Circulation Velocity and Gas Holdup in Multi-Tube Airlift Loop Reactor;
多管气升式环流反应器的循环液速和气含率
2.
In this paper, Kolmogoroff's theory of isotropic turbulence was applied to analyse characteristic parameters of an internal airlift loop reactor (ALR).
本文采用了柯尔莫哥洛夫(Kolmogoroff)各向同性湍流理论模拟气升式环流反应器中粘性非牛顿流体在上升段及下降段中的轴向返混,在应用该理论分析反应器的行为时,对环流反应器的输入功进行了推算,导出了非牛顿流体系统中的特征长度和特征速度,并且以此为基础进一步分析和推导了非牛顿流体中液相轴向返混系数的表达式。
3.
The growth of plant cell cultures of Taxus chinensis in the airlift bioreactor and stirred tank bioreactor is studied.
应用气升式生物反应器及搅拌式生物反应器悬浮培养红豆杉细胞 ,得到细胞生长和紫杉醇合成动力学曲线 。
6)  air-lift
气升式
1.
In air-lift loop reactor, the effects of gas velocity on liquid circulation velocity and gas hold-up were experimentally studied in the different systems, namely air-water, air-0.
在气升式环流反应器中,分别研究了空气-水、空气-0。
2.
A correlation of liquid circulation rate in a multi-tube air-lift loop reactor(MALR) was established on the basis of the momentum balance, in which a new method for the determination of the overall frictional-loss coefficient in air-water system was developed.
根据动量平衡原理建立了多管气升式环流反应器 (MALR)中液体速度的理论关系式 ,给出了流动阻力系数的计算方法 ;以Higbie的渗透理论为基础提出了计算液体表面微元在相界面暴露时间的方法 ,并建立了预测体积传质系数的模型方程 。
参考词条
补充资料:气升式发酵罐
分子式:
CAS号:

性质:需氧气的发酵过程都需要把反应液体搅拌。用搅拌桨通过机械的方式搅拌,不但消耗很多动力,而且容易把发酵罐中的细胞打碎。若在发酵罐内安装一个圆筒或隔板,把发酵罐的截面积划分为两部分,空气从其中一部分通入,气泡沿这部分的通道上升,则由于此通道内含有许多气体,故通道内的流体的平均密度比不通气的另一通道中的液体密度小。两个通道间的流体产生一密度差,使流体在这两个通道间循环流动,达到液体混合的目的。凡是利用这一原理产生液体循环流动的发酵罐都属于气升式发酵罐。也有利于气体喷射的动能或高压气体带动液体循环流动的,皆称为气升式发酵罐。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。