1) Manufacture variation
灌水器制造偏差
2) manufacture deviation
制造偏差
1.
5% and ±1%,then the uniformity of capillary tubes was calculated at different slope gradients and pressures in consideration of the manufacture deviation of drippers.
5%坡度和±1%坡度时,不同入口压力下滴头沿毛管的流量分布和水力损失,并结合滴头的制造偏差,计算得出不同坡度和压力条件下滴灌毛管的均匀度。
2.
On basis of current national standards “Calculation Method for Strength of Involutes Column Gear”, combining gear manufacture and appliance practice, the paper dissertates the influence of various common manufacture deviation to bearing capacity and other performance index of gear.
以现行“渐开线圆柱齿轮强度计算方法”国标为基础,结合齿轮制造及应用实际,分析论述了各种常见制造偏差对齿轮承载能力及其它性能指标的影响;同时,给出了诸项因素定量评价方法,有助于遇到工程实际问题时进行快速分析和判定。
3) manufacture deviation rate
制造偏差率
1.
At first, based on analyzing the actual calculation method of the hydraulic deviation rate and flux deviation rate, the ground deviation was presented and defined, the calculation method was set up, and the manufacture deviation rate of the drip douche was redefined.
在分析目前水力偏差率以及流量偏差率计算方法的基础上,提出并定义了地面偏差率,确定了地面偏差率的计算方法,并对原有灌水器制造偏差率进行了重新定义;综合考虑制造偏差、水力偏差和地面偏差,分别推导出了不同偏差影响下的流量偏差率计算公式,并推导出了综合流量偏差率和极限综合流量偏差率的计算方法。
4) manufacture flow deviation rate
制造流量偏差率
1.
With the production development and technology progress, in order to improve the design accuracy, it is necessary to take into consideration the effects of manufacture flow deviation rate and elevation flow deviation rate on the total flow deviation.
该文在已有高差流量偏差率的基础上,定义了滴头的制造流量偏差率、导出了3个流量偏差率最不利组合——流量总偏差率计算式,并提出了流量总偏差率允许值的建议。
5) depth-deviation indicator
深水偏差指示器
6) minimum bias controller
最小偏差控制器
补充资料：偏差报警器
分子式：
CAS号：
性质：用于检出变量偏离其预期值，并对超过一预量时报警的装置。一般是接收两个独立的信号，对其偏差正、负共同和分别报警。
CAS号：
性质：用于检出变量偏离其预期值，并对超过一预量时报警的装置。一般是接收两个独立的信号，对其偏差正、负共同和分别报警。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条