1) spray method
粉尘法
1.
The results showed that: the Mieke powder could effectively decrease the diseased fruit rate, diseased leave rate and disease index exhibiting higher control effect is higher than spray method.
对粉尘法防治保护地番茄灰霉病的效果进行试验,并与常规喷雾法进行了对比分析。
2) Using powder
粉尘法施药
3) dust
粉尘
1.
Measures and Effects of Decreasing Dust at Coal Blending Post;
降低配煤岗位粉尘的措施及效果
2.
Numerical simulation of the dust movement rule in fully-mechanized coal faces;
综采工作面粉尘运动规律的数值模拟
3.
Effect of Coat on Collecting Plates to Cohesive Force between Dust Particles and Collecting Plates for Electrostatic Precipitator;
静电除尘器收尘极板涂层对粉尘和极板之间粘结力的影响
4) powder
粉尘
1.
The formation of PET chip powder and the reduced measures;
PET切片粉尘产生的原因及减少的措施
2.
Study on active explosion suppression by powder in large-scale duct;
大型管道中主动式粉尘抑爆现象的实验研究
3.
Problem discussion on powder pollution at workplace in power plant;
发电厂作业场所粉尘污染有关问题的探讨
5) powder dust
粉尘
1.
Study on mechanism of powder dust production and comprehensively harnessing techniques in coal separation plant;
选煤厂粉尘产出机理及综合治理方案研究
2.
Occupational harmfulness of powder dust and control technology in coal preparation plant;
选煤厂粉尘的职业危害与控制技术
3.
A swashing dust catcher is used in the powder dust pollution in a-616 m underground crushing station of a copper mine in Anhui Province and the powder dust concentration at the working positions is reduced from 50 mg/m~3～60 mg/m~3 in the past to about 2 mg/m~3 at present.
采用1台冲激式除尘器对安徽某铜矿井下-616 m破碎站粉尘污染进行治理,作业岗位的粉尘浓度由原来的50 mg/m3~60 mg/m3,降至2 mg/m3左右,不仅使作业岗位的粉尘浓度基本达到了国家卫生标准,而且还净化了井下进风风质,改善了井下整体作业面空气环境。
6) gas dust
煤气粉尘
1.
The installation of fine dust on-line monitoring equipment in the BF gas dust-removing system and the entrance pipes of TRT unit can efficiently control the efficacy of dust bags and realize the on-line detecting of gas dust content in TRT unit entrance pipes,thus ensuring the running conditions of TRT unit and its long-term, high-efficient and safe running.
在高炉煤气除尘系统和TRT机组入口管道上安装粉尘在线监测装置,可对气布袋除尘效果进行有效控制,并实现TRT机组入口管道煤气粉尘含量的在线检测。
2.
The initiation of the cracks was caused by stress corrosion resulting from the co-effect of the corrosive gas dust and the axial tensile stress.
表面裂纹萌生原因是拉杆在腐蚀性高炉煤气粉尘和轴向拉伸等工作应力的综合作用下,形成的应力腐蚀裂纹。
参考词条
补充资料：法性属法为法性土
【法性属法为法性土】
谓真如法性之理，譬如虚空，遍一切处，乃是法身所证之体，即为所依之土，故名法性属法，为法性土。
谓真如法性之理，譬如虚空，遍一切处，乃是法身所证之体，即为所依之土，故名法性属法，为法性土。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。