1) air bubble intensity
气泡强度
1.
Damage rate had a positive correlation with air bubble intensity.
研究了给定气泡式清洗槽中的蔬菜损伤率与气泡强度的关系、最大清洗体积比与蔬菜密度的关系、洗净率和浊度与清洗时间的关系、清洗液浊度与清洗量和洗净率的关系等。
2) foaming intensity
发泡强度
1.
Average foaming life and foaming intensity of foaming process originated from reaction;
内生气源发泡过程的平均发泡寿命和发泡强度
2.
With modified version of the computer program and experimental data, the forming and rupture coefficients, as well as the average foaming life and the foaming intensity have been determined.
利用改进的计算程序和实验数据，计算了由分解反应引起的发泡和消泡参数及平均发泡寿命和发泡强度等特性参数通过分析可以看出，发泡过程方程在给定的积分区间泡内是一个收敛很快的级数，可以采用取消级数项的简化形式。
3) cavitation intensity
空泡强度
4) bubble scale
气泡尺度
5) bubble velocity
气泡速度
1.
The gas holdup and bubble velocity increased with increasing superficial gas velocity.
分析实验结果得出,气含率和气泡速度均随表观气速的升高而升高;在上升管内,气含率和气泡速度自中心向边壁逐渐降低,而沿轴向变化很小;在分布板区,由于受分布器及下降管的影响,使气含率和气泡速度在不同角向存在不同的径向分布。
2.
A capillary two phase flow system was set up and used to develop a double-sensor conductivity method for measuring two phase Taylor flow characteristics through a circular capillary,including bubble velocity,void fraction,bubble frequency and liquid slug length.
建立了单毛细管中两相流动传递参数实验系统,基于该系统开发了测取泰勒流下气泡速度、气含率、气泡频率以及液栓长度等参数的双电导测试系统。
3.
An image analysis method for measuring bubble velocity fields at high bubble number density is proposed.
提出了一种在高空隙率下气液两相流中气泡速度场的图像分析方法。
6) bubble density
气泡密度
1.
The effect of reducing cavitation damage in high-speed flow structure not only relate with entrained air concentration,but also relate with air bubble density has been discovered in recent research.
近年研究表明,高速水流泄水建筑物的掺气减蚀效果,不仅与掺气浓度有关,还应考虑气泡密度;认为0。
补充资料：表光合强度(见光合强度)
表光合强度(见光合强度)
forecast of sowing or transplanting time
b iaoguanghe qiangdu表光合强度见光合强度
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条