1) vertical embedded depth
垂直埋置深度
2) embedded depth
埋置深度
1.
The paper mainly discusses embedded depth of foundation,partial fixing of Superstructure Construction,constraint action of backfilled soil and loads of basement based on the complexity and variety of structure model of High-Rise basemen.
高层建筑上部荷载大,基础埋置深度也较深,地下室的设计合理与否直接影响建筑物的正常使用与造价。
2.
This article aims to study how single-screw anchor works in sand through indoor test,gives the calculation formula of critical embedded depth and provides theoretical basis for the instruction of engineering practice.
结果在相同埋深的条件下,上拔极限承载力随锚片直径的增加而增加;在锚片直径不变的情况下,浅埋时承载力随埋深的增加而增加,但当埋深达到临界埋置深度后,承载力不再随埋深的增加而明显增加,而趋于稳定。
3.
Based on the stability analysis of large caisson foundations in Sutong Bridge, this paper represented that if the bearing capacity requirement on the caisson foundation base is satisfied, it is not true that the embedded depth of the caisson foundation is the larger the better, and the depth needs not to be large.
对苏通大桥沉井基础稳定性的计算分析表明,在满足基底承载能力要求时大型沉井的埋置深度不是越深越好,并且不需要太大。
3) embedment depth
埋置深度
1.
Tensile experiments of bonded-in reinforcements group have been completed with embedment depth 10d and 15d(d is rebar diameter) respectively.
建议工程应用中最小埋置深度取15d,并提出植筋群受拉承载力计算式。
6) TVD
总垂直深度
补充资料：BCS穿透深度（BCSpenetrationdepth）
BCS穿透深度（BCSpenetrationdepth）
对纯超导体，由BCS电流方程，在伦敦极限下（`\xi_0\lt\lt\lambda`或$l\lt\lt\xi_0$）的穿透深度与伦敦穿透深度λL(T)相符。对非纯超导体（含杂质），在伦敦极限下为
$\lambda(T)=\lambda_L(T)(1 \xi_0//l)^{1/2}$
一般地，λL(T)由经验公式表示其与温度T的关系（见“伦敦穿透深度”）。在皮帕德极限下（$\xi_0\gt\gt\lambda$或$\xi_0\lt\ltl$），ξp=ξ0，则给出为
$\lambda(T)=\frac{8}{9}\lambda_L(T)[\frac{sqrt3\xi_0}{2\pi\lambda_L(T)}]^{1/3}$
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条