说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 积分平均传热温差
1)  integral mean tempereture difference of heat transfer
积分平均传热温差
2)  margin calculation of diathermanous average tempera-ture
传热平均温度差
3)  mean temperature difference
平均温差
1.
Formulae for calculating the mean temperature difference of rubber to cooling medium in reclaimator and heat transfer coefficient of system have been derived from theory.
从理论上推导出脱硫挤出机中胶料与冷却介质的平均温差及系统的传热系数的计算公式,并结合准数关系式及实验对传热能力和胶料与机筒内壁的对流传热系数进行了计算。
2.
This paper, according to heat transfer basic equation, deduces overall heat transfer coefficients in the transmit heating tube of the pure counterflow arrangement, axial temperature profile of the fluid along the length of transmit heating tube, simulates logarithmic mean temperature difference in a double tube and the effective overall heat transfer coefficient, wi.
本文根据传热基本方程推导纯逆流传热套管的总传热系数,沿传热管长度的流体轴向温度分布,模拟二重套管的对数平均温差和有效总传热系数以便于工程设计计算。
3.
The logarithmic mean temperature difference and the integral mean temperature difference are analyzed in the optimum design of heat exchanger,the proposed approximate equations of logarithmic mean temperature difference in the literatures are discussed.
分析比较了在换热器的优化设计中,当流体的比热或传热系数随温度变化时的对数平均温差(LMTD)和积分平均温差计算方法;同时对有关文献中已提出的近似计算方法进行了讨论,指出 Chen JJJ 提出的近似公式最适用于换热器的优化设计。
4)  integral temperature
平均温度;积分温度
5)  heat transfer temperature difference
传热温差
1.
Study on heat transfer temperature difference between non-heated staircase and adjacent heated rooms;
非供暖楼梯间与供暖邻室传热温差的研究
2.
Based Stirling ideal refrigeration cycle,the heat transfer temperature differences in the cold end and heat end of Stirling cooler were dealt with dimensionless method.
基于斯特林理想制冷循环,对斯特林制冷机冷热端的传热温差进行无量纲化,分析了传热温差对斯特林制冷系数的影响关系。
3.
With the relationship between the pressure drop and the heat transfer temperature difference in the gas turbine recuperator included,the heat transfer difference can be further recommended as the evaluation criterion instead of the recuperator effectiveness for recuperative gas turbine cycles.
本文考虑了回热器传热温差与流动阻力损失的关系,进一步论证了燃气轮机回热循环的评价准则可采用传热温差代替传统的回热度。
6)  integral average
积分平均
1.
Using the method of integral average technique and defining a new prepared solution,this paper presented some new oscillation criteria of matrix differential equations with damping,which extend the results of Rogovchenko and Li for scalar cases and improve the results of Yang for matrix cases; a few examples was given at the end.
通过积分平均技术及定义新的预备解,给出了带阻尼项的二阶矩阵微分方程的一些振动性准则;把Li和Rogovchenko中纯量微分方程的结果推广到了矩阵微分系统;同时改进了Yang的一些结果;最后给出了几个例子说明这些结果的应用。
补充资料:传热温差
分子式:
CAS号:

性质:加热蒸气的温度与溶液的沸点之差。在蒸发过程中必须不断地向溶液供给热能,良好的传导传热也必须有一定的传热温差。传热温差越大,则越有利于蒸发过程的进行。提高传热温差可通过:(1)提高加热蒸气的压力,但不适当的提高可能导致热敏性成分的损失;也是不经济的;(2)借助减压方法适当地降低冷凝器中二次蒸气的压力,在提高传热温差的同肘,也降低了溶液的沸点。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条