1) slotted casing treatment
折线斜缝式处理机匣
2) combined casing treatment
组合式处理机匣
1.
Experimental investigation of a solid/arc slot asymmetrical combined casing treatment
实壁/圆弧斜槽周向不对称组合式处理机匣实验
3) casing treatment
机匣处理
1.
Unsteady numerical analysis for casing treatment;
机匣处理的非定常数值分析
2.
CFD study on casing treatment in a transonic compressor;
跨声速压气机机匣处理的数值研究
3.
Numerical analysis of two circumferential groove casing treatments about a centrifugal compressor
离心压气机周向槽机匣处理方案的对比分析
4) casing treatment
处理机匣
1.
Plenum chamber casing treatment——numerical research of internal flow and mechanism of stall margin improvements;
驻室式处理机匣——内部流动及扩稳机理的数值研究
2.
3D numerical analysis for the effect between tip clearance and casing treatment in turbomachinery;
压气机间隙流与处理机匣作用的三维数值分析
3.
Design of a slot-type casing treatment and its experimental validation;
一种槽道式处理机匣设计及实验验证
5) axial skewed slot casing treatment
轴向斜槽处理机匣
1.
Experimental and numerical investigations were conducted to study the fundamental flow mechanisms of the axial skewed slot casing treatment of a HP compressor and the influence on compressor stall margin.
本文主要采用数值模拟和试验验证的方法探索轴向斜槽处理机匣改善高压压气机尖部流动情况及扩大压气机稳定工作边界的基本原理。
6) circumferential groove casing treatment
周向槽处理机匣
1.
A circumferential groove casing treatment was designed,the effects of circumferential casing treatment on the performance and flow field of a transonic axial flow compressor rotor was numerically investigated by performing a 3-D steady-state Navier-Stokes analysis.
结果表明,数值模拟结果与实验结果符合良好,该周向槽处理机匣使压气机转子的失速点流量减小了11。
2.
Role of tip leakage flow on flow instability and its control with circumferential groove casing treatment;
在此基础上,利用周向槽处理机匣结构对顶部间隙泄漏流进行控制,并探讨了周向槽处理机匣结构提高压气机稳定工作裕度机理。
补充资料：成都无缝钢管厂管坯在菌式穿孔机上穿孔
成都无缝钢管厂管坯在菌式穿孔机上穿孔
成都无缝钢管厂管坯在菌式穿孔机上穿孔
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条