1) gas-eliminator hole
排汽孔
2) exhaust steam
排汽
3) boiler
排汽噪声
1.
The principle of control on boiler exhaust noise were discussed in the paper.
阐述了大型锅炉排汽噪声治理的原理。
4) exhaust facility
排汽装置
1.
By combining k-ε models with the wall function calculation method and using the SIMPLE method for programming,the flow field in exhaust facility,which has a low pressure heater and pressure reducer and desuperheater in it,has been treated with three-dimensional numerical simulation and the velocity distribution of the flow field in exhaust facility is herewith obtained.
采用k-ε模型并结合壁面函数法,利用SIMPLE算法编程,对某具有内置式低压加热器和减温减压器的直接空冷汽轮机排汽装置的内部流场进行了三维数值模拟,得到了整个排汽装置内部流场的速度分布情况。
2.
The article presents the structural features,requirements of installation and test,means and operation for exhaust facility of 600MW direct air-cooled turbine to make readers fully understanding about the (exhaust) facility.
对直接空冷600MW机组排汽装置的结构特点、安装与试验要求、方法及运行进行了论述,让读者对排汽装置有比较全面的了解,对电厂的现场安装、试验及运行起指导作用。
3.
By combining SIMPLE algorithm and model,the three-dimensional numerical simulation has been made for the flow field in 300MW exhaust facility,which has a low pressure heater in it,for direct air cooling unit and the velocity distribution of the flow field in entire exhaust facility has been obtained.
采用SIMPLE算法和k-ε模型,对内置低压加热器的300MW直接空冷机组排汽装置的内部流场进行了三维数值模拟,得到了整个排汽装置内部流场的速度分布情况。
5) exhaust enthalpy
排汽焓
1.
Novel on-line calculation models for steam turbine exhaust enthalpy and its application;
汽轮机低压缸排汽焓在线计算新模型的研究及应用
2.
A new online model for calculating the exhaust enthalpy was proposed aiming at the limitation of existing online calculation model for calculating the enthalpy of steam turbine LP exhaust hood.
针对现有的汽轮机低压缸排汽焓在线计算模型存在一定的局限性,提出了一种排汽焓在线计算新模型。
3.
When calculating the efficiency of low pressure cylinder,it used the power-balance equation and curve fitting to compute the exhaust enthalpy.
采用功率平衡方程式反推与曲线拟合相结合的方法计算汽轮机的末级排汽焓,解决了排汽湿度难以测量的问题。
6) exhaust pipe
排汽管道
1.
The mathematical model for two-phase flow and heat transfer of wet steam in exhaust pipe for a 600 MW power generating unit with direct air cooling is established.
建立了600 MW发电机组直接空冷排汽管道内湿蒸汽两相流动和传热的数学模型。
2.
In Hanfeng Power Plant the deformation caused displacement of a 660 MW set s BFPT exhaust pipe effected a gland clearance change of the auxiliary turbine.
河北邯峰电厂660 MW机组小汽轮机排汽管道产生65 mm位移,促使小汽轮机汽封间隙变化,影响小汽轮机试运行。
参考词条
补充资料：阻汽排水阀
分子式：
CAS号：
性质：又称疏水器，阻汽排水阀，冷凝水排除器。自动排放冷凝水并阻止蒸汽泄漏的阀门。型式较多，根据操作原理可分为两种：（1）自动排水式。借蒸汽本身的压力将冷凝水排出，例如浮球式疏水阀、浮杯式疏水阀、孔板式疏水阀等。（2）压出式疏水阀。借外加蒸汽压力将冷凝水排出。根据操作方法分为两种：（1）连续式疏水阀，例如浮球式疏水阀、孔板式疏水阀、压出式疏水阀。（2）间歇式疏水阀，例如浮杯式疏水阀。
CAS号：
性质：又称疏水器，阻汽排水阀，冷凝水排除器。自动排放冷凝水并阻止蒸汽泄漏的阀门。型式较多，根据操作原理可分为两种：（1）自动排水式。借蒸汽本身的压力将冷凝水排出，例如浮球式疏水阀、浮杯式疏水阀、孔板式疏水阀等。（2）压出式疏水阀。借外加蒸汽压力将冷凝水排出。根据操作方法分为两种：（1）连续式疏水阀，例如浮球式疏水阀、孔板式疏水阀、压出式疏水阀。（2）间歇式疏水阀，例如浮杯式疏水阀。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。