1) Jet combustion
射流燃烧
1.
According to the current popular Non Uniform Rational B spline (NURBS) principles in the international CAD/CAM field, this paper studies the surface modelling and fitting of the tube of Jet combustion gasoline engine cylinderhead.
本文以当前国际上ＣＡＤ／ＣＡＭ领域最流行的非均匀有理Ｂ样条（ＮＵＲＢＳ）理论为数学模型，对射流燃烧汽油机缸盖模具的气道进行了曲面造型和曲面拟合；并结合气道曲面的实际，在数控加工中对气道曲面通过轴心线实施了分段剖分，并采用参数线法确定了刀心轨迹，进行刀具轨迹仿真，获得了数控加工气道曲面和型芯的ＮＣ程序。
2) TJ Jet combustion chamber
射流燃烧室
1.
On the basis of the measured indicator diagram and NO x emission of a single cylinder gasoline engine with TJ Jet combustion chamber,a new improved multi zone combustion diagnostic model is used to get the heat release rate,the average temperature of burned gas and NO x formation rate as well as other important parameters.
对采用射流燃烧室的新型高压缩比稀混合气 492 QS车用汽油机 ,在单缸机实测示功图和 NOx 排放数据基础上 ,结合由新改进的多区燃烧分析模型经计算得到的燃烧放热率、已燃气体平均温度、NOx生成率等有关结果 ,分析了燃烧特性与 NOx 生成特性之间的关系。
2.
This paper describes an investigation on the applications of TJ Jet combustion chamber in the vehicle gasoline engines.
本文介绍了射流燃烧室在车用汽油机上的应用研究。
4) multi-jet burner
多股射流燃烧器
1.
A numerical simulation was carried out on the High Temperature Air Combustion in an industrial furnace with a multi-jet burner.
以高温空气燃烧技术为应用背景,对多股射流燃烧器的燃烧特性进行了数值模拟,讨论了燃料与空气射流喷口间距对燃烧特性的影响。
5) free jet burner
自由射流燃烧器
6) half-injection swirl-flow gas burning installation
半引射旋流燃烧装置
补充资料：沸腾床燃烧(见流化床燃烧)
沸腾床燃烧(见流化床燃烧)
boiling-bed combustion:see fluidized-bed combustion
沸腾床燃烧(boiling一bed eombustion)见流化床燃烧。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条