1) compressiontraction test
拉压实验
1.
This paper deals with a presentation of simple compressiontraction test and an analysis of the strength constitution characteristics of bituminous mixtures.
以沥青混合料为研究对象，在给定三种实验变量（沥青用量、孔隙比、实验温度）的条件下，通过简单拉压实验，用Ｍｏｈｒ－Ｃｏｕｌｏｍｂ理论分析了这种颗粒性材料的强度构成特性及其内在参数ｃ—φ值，并探讨了材料的粘性与非粘性性质，以及沥青和骨料在混合料的强度形成中分别所起的作用。
2) experiment on pull and compress
拉伸压缩实验
3) simple tension test
简单拉压实验
4) tensile test
拉伸实验
1.
In the tensile test the strength of joint was higher than that of base plate.
8mm CuSi3,通过优化选择工艺参数,获得了成型良好的钎焊接头,通过钎焊接头厚度的加强,在拉伸实验中,钎焊接头的强度超过了母材。
2.
Femoral venous strips and rings were used to make uniaxial tensile test of the longitudinal and circumferential specimens of the vessels.
各组取股静脉,做成血管条及血管环并分别做轴向和环向拉伸实验;对照组和实验组的血管试样均行显微结构观察。
3.
The data of the seal strength were obtained by tensile test.
通过对冠盒式容器封口的拉伸实验,获得了容器封口强度的实验数据。
5) tension test
拉伸实验
1.
Force and deformation of ring specimen during hoop tension test were analyzed.
通过等宽试样和标距试样拉伸实验,对理论分析结果进行了验证。
6) drawing experiment
拉拔实验
1.
Through a series of drawing experiments of brass wires, the effects of ultrasonic vibration on drawing force and surface quality of the wires were discussed.
系统由超声波驱动器、换能器、变幅杆、拉丝模、拉伸机等组成,通过对黄铜丝的拉拔实验,考察了超声振动对拉拔力和丝的表面质量的影响。
2.
In order to improve the load-bearing capacity and useful life of anchor cable,design new anchor cable anchorage,through static load drawing experiment of anchor cable,simulation the various situations may arise in application,regulation angle between the centerline anchor cable and the anchorage face,loading until destruction.
为了提高锚索的承载能力和使用寿命,设计了新型球面锚索锚具,通过锚索静载拉拔实验,模拟锚索在应用中可能出现的各种情况,调节锚索中心线与锚固面的角度,加载直到破坏。
补充资料：保险商实验室安全标准(见保险商实验室)
保险商实验室安全标准(见保险商实验室)
safety standards of UL: see Underwriters Laboratories; UL
Baoxianshang Sh啊nshi anquan bicozhun保险商实验室安全标准(saJ七ty stand助dsofUL)见保险商实脸室。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条