1) pull-out length
拔出长度
1.
The relations between pull-out length and pull-out load are given.
从能量原理出发，把钢筋混凝土看成为一种纤维增强复合材料，利用已有的实验回归公式，推导出了钢筋混凝土中钢筋与混凝土的脱开条件给出了钢筋的拔出长度与拔出载荷的关系
2) maximum pull-out length
最大拔出长度
1.
By Using energy principle to study root\'s cracking resistance and enhancement action,a calculating formula of shear strength increment of one point in the composite of root and soil was educed,and the formulas of root\'s resistance pull-out risistance and maximum pull-out length in the point too.
并运用能量原理对根系的阻裂增强作用进行了分析研究,得出根土复合体中某点的抗剪强度增量的计算公式及该点处根系的抗拔力和最大拔出长度的计算公式,得出某点抗剪强度增量主要与该点处根的面积比、面密度、长径比、抗拉强度、根土间的黏聚力及摩擦系数有关,及如果根系深入某点以下锚固段长度大于该点处的最大拔出长度,根系将被拉断的结论。
3) pullout strength
拔出强度
1.
Objective To investigate the influence of screw length(18,20,and 24 mm) on the axial pullout strength of full thread cancellous screws.
目的探讨螺钉长度对全螺纹松质骨螺钉轴向最大拔出强度(Axialmaximumpulloutstrength)的影响。
4) pullout
[英]['pu:l,aut] [美]['pul,aʊt]
拔出
1.
This paper presents the results of 28 pullout bond tests on fiber reinforced polymer FRP bars embedded in concrete.
进行了28个纤维聚合物(FRP)筋拔出粘结试验,试验变量为FRP筋种类、FRP筋直径、混凝土强度和粘结长度,拔出试验记录了拔出荷载、FRP筋加载端滑移、破坏现象。
2.
Finite element method was used to analyze the stresses in the whisker - matrix interface of Al2O3/SiCw ceramic comPOsite when whisker pullout was occurred, the stresses distribution was also obtained.
采用有限元的方法分析了Ａｌ_２Ｏ_３／ＳｉＣ_ｗ陶瓷材料晶须拔出时材料中的应力状态及应力分布，研究了晶须拔出时材料界面的断裂模式。
5) pull-out
拔出
1.
Mechanical behavior in the pull-out process of NiTi SMA fiber;
NiTi形状记忆合金纤维拔出中的力学问题
2.
The distribution of normal stress in fiber and interfacial shear stress were obtained as well as the axial pull-out force.
5 mm)拔出为例,对橡胶-纤维复合材料不同温度下的界面力学性能进行了数值分析,得到了相应的应力场分布和拔出载荷的变化。
3.
The interface properties of nylon fiber-rubber composites were studied by using single fiber pull-out method.
采用单纤维拔出的方法,研究了不同温度下尼龙纤维-橡胶复合材料的界面特性。
6) pull out
拔出
1.
The interfacial debonding strength between polypropylene filament and cement paste and its affecting factors were studied by use of pull out method.
采用纤维单丝自水泥基体中拔出方法研究了聚丙烯纤维单丝与水泥石之间的界面脱粘强度及其影响因素 。
补充资料：出下
1.做出;做下。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条