1) bending members
受湾构件
2) compression member
受压构件
1.
Non-linear analysis of fire resistance of RC compression members;
钢筋混凝土受压构件防火性能的非线性分析
2.
Based on the plane section assumption and the formulas of compression members with small eccentricity,the interaction diagram of ξ and the linear interpolation formula of ξ according to the calculation of rectangular section capacity with symmetrical reinforcement are presented.
根据平截面假定和小偏心受压构件的基本公式,提出了两种钢筋混凝土矩形截面小偏心受压构件对称配筋的简化计算方法,并应用两个相关实例进行验证,具有良好的效果,为今后设计计算改进和提高提供了依据。
3) compressed member
受压构件
1.
The computing formula about the lateral deflection f and its corresponding coefficient η to the arbitrary cross-sections of the compressed member under different ending moments and constraint conditions are obtained.
针对现行规范中受压构件偏心距增大系数η的计算公式在应用方面存在的某些不足,采用有限元迭代法并考虑二阶弯矩的影响,得出在不同端弯矩和约束条件下偏心受压构件任意截面处侧向挠度f与相应的η计算公式。
4) compression members
受压构件
1.
This paper presents the math, model for optimization design of the con- crete filled steel tubular compression members, and utilizes the complex method for carrying on optimization design.
给出了钢管混凝土受压构件优化设计的数学模型、并且利用复形法进行了优化设计,给出了求钢管混凝土受压构件最优解的计算框图。
5) flexural member
受弯构件
1.
Calculation of carrying capacity of the normal section of a RC flexural member with round section;
钢筋混凝土圆截面受弯构件正截面承载力计算
2.
Simplified method of reinforcing the grouted concrete flexural members;
现浇钢筋混凝土受弯构件加固补强简易方法
3.
Simplied calculation to the minimum reinforcement ratio of flexural members to be content crack;
满足裂缝要求的受弯构件最小配筋率的简化计算
6) flexural members
受弯构件
1.
Control of crack width in reinforced concrete flexural members;
钢筋混凝土受弯构件裂缝宽度控制
2.
Deflection of preflex prestressed concrete flexural members;
预弯预应力混凝土受弯构件的挠度计算
3.
Experimental study on behavior of cold-formed steel flexural members with thickness less than 2mm
壁厚2mm以下冷弯薄壁型钢受弯构件性能试验研究
补充资料：曲曲湾湾
1.形容很弯曲。 2.比喻事情经过许多曲折。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条