说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 间歇供水
1)  intermittent application
间歇供水
1.
By simulating the infiltration of intermittent application dynamically, the infiltra-tion mechanism of surge irrigation and the quantitative index describing the effect of surgeirrigation are studied.
通过间歇供水土壤水分入渗过程的动态模拟,探讨了间歇供水的入渗机理,提出了描述波涌灌效果的指标──—后续供水入渗速度的折减系数。
2)  intermittent water application
间歇供水
1.
Comparing with continuous water application, intermittent water application showed a clear advantage in reducing water infiltration in horizontal while still not significantly affecting the horizontal distribution.
间歇供水和连续供水方式下的地表点源入渗进行了室内对比研究,得到以下初步的结果:2种供水方式下水平和垂向湿润锋与入渗时间均存在显著的幂函数关系;在灌水定额相同的条件下,采用大滴头流量(2L/h)间歇滴灌同采用小滴头流量(1L/h)连续滴灌相比较,间歇供水能有效增加水平与垂向湿润距离的比值;在连续供水条件下,土壤湿润体内平均含水率保持为一常量,而间歇供水处理的湿润体内平均含水率有一周期性的动态变化,供水期持续增大,在停水期降低接近于连续供水处理。
3)  Intermittent water supply
间歇性供水
1.
Functional knitting is made of abnormity terylene and Lanseal fiber,this intensifies heat-transfer capacity of water film and evaporative cooling of water film surface;Intermittent water supply guarantees that the n.
从吸水性材料、换热器结构及布水方式入手,设计了采用功能性纤维套、铝箔椭圆管和间歇性供水方式等强化换热措施的间接蒸发冷却器结构。
4)  intermittent nitrogen supply
间歇供氮
1.
The process and mechanism of ion nitriding with pure nitrogen were studied by way of continuous nitrogen supply simultaneously with vacuum pumping and furnace shutdown after intermittent nitrogen supply,respectively,under cathode voltage of 500,600,650 and 700 V.
分别研究了在500、600、650和700 V阴极电压条件下采用连续供气抽真空和间歇供氮闭炉的方式进行纯氮离子渗氮的工艺及机理。
5)  intermittent power supply
间歇供电
1.
In consideration of the problems of low efficiency of walking-beam pumping units and electric energy stolen in the oilfields, a new device, which is power saving and electricity-stealing prevention, is developed for voltage regulation and intermittent power supply for the walking-beam pumping units.
针对游梁抽油机电动机效率低和井场窃电问题,研制了具有节电和防井场窃电功能的游梁抽油机调压+间歇供电装置。
2.
:duty ratio,frequency and polarization potential of cathodic protection (CP) by intermittent power supply on effectiveness of protection for carbon steels were investigated by experimental methods.
实验研究间歇供电阴极保护的频率 ,占空比 ,极化电位等参数对碳钢保护效果的关系 。
3.
As for those problems mentioned above,a method of intermittent power supply of constant voltage source is introduced in this paper,which.
针对电桥存在的上述问题提出的恒压源间歇供电方式,不仅可以提高传感器的灵敏度,还有效地降低了应变片电阻的“温升”和热噪声,提高了传感器的精度。
6)  intermitting heating
间歇供热
1.
But in the middle and lower reaches of Chang-Jiang river,because it is not very cold in winter,the research indicates the insulated inner wall can improve the comfortableness of the human body in the room with intermitting heating.
大多数观点认为外墙外保温要比内保温好,这表现在墙体保护、防止外墙内壁面结露以及少占用室内空间,但在长江中下游地区,由于冬季室外温度并不是非常寒冷,在间歇供热条件下,研究显示外墙内保温要比外保温可以提高人体热舒适性。
2.
Directing against the relationship between the thermal comfortableness of human bodies and the room and the inner wall temperature, a mathematical model was proposed and tested for the room temperature response to the intermitting heating in a room with walls built with composite materials.
对此,本文做了以下几项工作:间歇供热条件下,复合材料墙体室内温度响应的理论研究:依据非稳态传热理论,建立建筑物各种围护结构的温度变化详细理论模型,用以描述室内外条件变化时围护结构本身的温度变化规律。
补充资料:泵阀等供水设备及主要配件基础知识

A、水泵基础知识知识


    常用水泵型号代号
    LG-----高层建筑给水泵
    DL------多级立式清水泵
    BX-------消防固定专用水泵
    ISG------单级立式管道泵
    IS -------单级卧式清水泵
    DA1-------多级卧式清水泵
    QJ-------潜水电泵


    泵型号意义:如40LG12-15;40-进出口直径(mm);LG-高层建筑给水泵(高速);12-流量(m3/h);15-单级扬程(M)。
    200QJ20-108/8。200---表示机座号200;QJ---潜水电泵;20—流量20m3/h;108---扬程108M;8---级数8级。


    水泵的基本构成:电机、联轴器、泵头(体)及机座(卧式)。[见图]


    水泵的主要参数有:流量, 用Q表示,单位是M3/H ,L/S。扬程,用H表示,单位是M。


    对清水泵,必需汽蚀余量(M)参数非常重要,特别是用于吸上式供水设备时。


    对潜水泵,额定电流参数(A)非常重要,特别是用于变频供水设备时。


    电机的主要参数:电机功率(KW),转速(r/min),额定电压(V),额定电流(A)。


    联轴器    泵头(体_)    卧式机座


    B、压力容器基本知识


    1、压力:压力是垂直作用于物体单位面积上的力。确切名称是压力强度,简称压强,习惯上叫做压力[kgf/cm2]。压力的单位一般用大气压,在工程单位中用公斤/厘米表示,也可以用水柱或水银柱表示,国际统一单位是牛顿[N/mm2]、帕或兆帕[MN/m2 、 Mpa]。1工程大气压[kgf/cm2]=0.098牛顿[N/mm2]=0.098帕[MN/m2]=0.098兆帕[Mpa]=10米水柱的压强。


    2、容器:容器是由曲面构成用于盛装物料的空间构件。容器大体是由:筒体、封头(端盖)、发兰、支座、接管、人孔等组成。


    3、补气式、囊式供水设备罐体的总容积、可调水容积计算及水泵启动次数:


    VZ=Vx/1-αb  Vs=βCqb/4nmax  Vo=Vs(β-1)/(1-αb)


    筒体重量计算:W=7.85Dnπhδ/106[Kg]。


    封头的下料参考尺寸Ø =1.2Dn+2S+2倍直边高度(25、40、50)mm


说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条