1) chilled cast anchor device
冷铸锚
1.
Compared with the conventional stuffing used for chilled cast anchor device, the new type stuffing for the same has two major advantages, firstly, it is non poisonous, non stimulus and is highly workable.
新型冷铸锚填料与传统的冷铸锚填料相比有两大优点：第一，无毒、无刺激性，施工性能好；第二，高温热稳定性显著提高。
3) hot casting socket
热铸锚
1.
By the research of both the suspending strand of HUMEN bridge and the footbridge of JIANGYIN bridge, it is introduced at length in this article that the results of testing research and the analysis of the hot casting in the two bridges hot casting sockets.
通过对广东虎门大桥吊索和江苏江阴大桥猫道索的制作课题研究 ,详细介绍了这 2座桥绳索热铸锚灌铸工艺的试验研究结果和分析以及所确立的纽绞钢丝索热铸锚灌铸工艺 。
4) cast steel anchor cable
铸钢锚缆
6) chilled cast iron
冷激铸铁
1.
In order to eliminate the high content of ferrite structure in the outer layer with depth of 1 mm of the chilled cast iron camshaft produced in shell mould,an experiment with adding metal antimony into iron melt was conducted.
为消除用覆膜砂壳型铸造工艺生产的冷激铸铁凸轮轴主轴颈外表面1 mm左右深度内的大量铁素体组织,进行了在铁液中加入金属锑的试验,加入量(质量分数)分别为:0。
2.
The "black line" defect found on chilled cast iron camshafts was analyzed metallographically and found that the microstructure of defect zone consisted of pearlitic matrix and D-type graphite.
对冷激铸铁凸轮轴的"黑线"缺陷进行显微分析发现,缺陷区的基体组织为珠光体,石墨形态为枝晶点状石墨。
补充资料：p-甲苯磺酸吡啶锚
分子式：
CAS号：
性质：熔点117～119℃。对湿气敏感的具刺激性固体。用吡啶与对甲苯磺酸反应制取。在合成保护羟基的四氢吡喃醚，以及合成保护羰基的缩醛或缩酮时，用作催化剂。亦可用以断裂甲氧基乙氧基醚(MEM)或甲氧基甲基醚(MOM)。
CAS号：
性质：熔点117～119℃。对湿气敏感的具刺激性固体。用吡啶与对甲苯磺酸反应制取。在合成保护羟基的四氢吡喃醚，以及合成保护羰基的缩醛或缩酮时，用作催化剂。亦可用以断裂甲氧基乙氧基醚(MEM)或甲氧基甲基醚(MOM)。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条