1) thick film strain resistor
厚膜应变电阻
1.
We constructed a strain sensitive model through the analysis of the Ru-based thick film strain resistor s tunneling barrier model.
通过分析钌基厚膜应变电阻的隧道势垒模型,提出力敏模型。
2.
The relationship between the resistivity and the resistor-strain coefficient of the thick film strain resistor wasstudied.
制备了不同表面电阻率的Ｒｕ基厚膜应变电阻浆料，研究了厚膜应变电阻的表面电阻率与电阻应变系数之间的关系，并对其导电机理与特性进行了分析。
2) Ru-based thick film strain resistors
钌基厚膜应变电阻
1.
In this paper the fundamental formula of capillarity is employed on the Ru-based thick film strain resistors in the progress of sintering, and the consequence is used to interpret some experimental phenomena .
本文将毛细作用的基本公式应用于钌基厚膜应变电阻的烧结过程,建立厚膜应变电阻玻璃扩散、渗透的数学模型,并用该模型对一些试验现象进行了分析,较好地解释和探讨了导电相粒径、烧结时间等对方阻的影响。
3) thick film resistors
厚膜电阻
1.
A way of using BaPbO_3/Ag as the conductive phase to prepare lowcost and high-power thick film resistors was proposed.
提出以BaPbO3/Ag复合体系作为功能相制备低成本大功率厚膜电阻浆料的思想,研究Ag含量、峰值烧结温度对厚膜电阻电性能和热稳定性的影响,并从导电机理方面对实验结果进行了分析讨论。
4) Thick film resistor
厚膜电阻
1.
Fabrication of thick film resistors by laser micro-cladding resistor pastes;
用激光微细熔覆法直写电阻浆料制备厚膜电阻
2.
Specific thick film resistor with high-power and small size has been developed,and explosion-proof problem of PDA has been solved to ensure the safe use in special places.
介绍了一款掌上电脑,综合应用厚膜电子技术和本安防爆技术,研制了具有大功率、小体积的专用厚膜电阻,解决了掌上电脑的防爆难题,确保其在特殊场所的使用安全,极大地提高了工作效率。
3.
We introduced three kinds of thick film resistor(TFR) conductive model.
介绍钌基厚膜电阻的三种传导模型。
5) thick-film resistors
厚膜电阻
1.
Effect on properties of thick-film resistors was studied when inorganic binder phases were changed.
采用钙铝硅玻璃和硼硅酸铅玻璃组成的复合体系作为无机粘结剂制备厚膜电阻浆料,研究复合无机粘结剂对厚膜电阻各性能的影响。
2.
The paper mainly studies the reliability of multi-layer intercnonections,vias and thick-film resistors in Multi-chip Module-Ceramic(MCM-C) substrates.
重点研究了MCM-C基板中多层互连和厚膜电阻的可靠性。
3.
This paper mainly studies the life distribution and degradation law of the thick-film resistors in Multi-chip Module Ceramic (MCM -C) .
重点研究了MCM—C基板的可靠性,包括厚膜电阻、基板布线以及互连通孔。
6) thick-film resistor
厚膜电阻
1.
A novel technique of laser micro-cladding is used to flexibly and directly fabricate thick-film resistors on ceramic substrate.
采用激光微细熔覆柔性直写技术在陶瓷基板上制备厚膜电阻。
2.
Reliability Study on Multi-layer Substrates of MCM and Thick-film Resistors;
本研究重点研究了MCM—C基板的可靠性，包括厚膜电阻，基板布线以及互连通孔。
补充资料：电阻应变仪
分子式：
CAS号：
性质：一般也称电阻应变仪。有线应变仪、箔应变仪、半导体应变仪等。随着变形会发生电阻值变化的应变片按规定方向贴在试件表面，由于试件表面应变造成应变片的电阻值变化。人们用高灵敏度检流计测出电阻值的变化。并用此推得应变值的大小变化。应变仪广泛应用于材料的力学性能检测中，例如测定材料拉伸模量，就是用所加负荷和同时由贴在试件表面的应变片测出的应变值经计算而得。
CAS号：
性质：一般也称电阻应变仪。有线应变仪、箔应变仪、半导体应变仪等。随着变形会发生电阻值变化的应变片按规定方向贴在试件表面，由于试件表面应变造成应变片的电阻值变化。人们用高灵敏度检流计测出电阻值的变化。并用此推得应变值的大小变化。应变仪广泛应用于材料的力学性能检测中，例如测定材料拉伸模量，就是用所加负荷和同时由贴在试件表面的应变片测出的应变值经计算而得。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条