1) grout consumption rate
耗浆率
1.
By the discussion of the present status of the analysis,assessment and study of the rock mass groutability, the paper presents a new physical quantity——grout consumption rate and uses it to describe the rock mass groutability.
该文通过对岩体可灌性的分析、评价和研究现状的讨论 ,提出了一个新的物理量———耗浆率 ,用来描述岩体可灌性 ,并以此为基础对岩体可灌性进行分级评价 ,从而为岩体可灌性的定量分析和研究提供了一种新的参数。
2) pulp consumption
浆耗
1.
Adopting bicomponent retention system greatly improved filler retention rates, thereby increasing the amount of filler to increase the content of filler in paper, lower pulp consumption and costs.
通过改用助留系统,大大提高填料留着率,从而提高纸张中填料的含量,降低浆耗和成本。
3) refining energy
磨浆能耗
1.
Fiber morphology,dewatering rate,paper property and refining energy were researched after softwood long fibers were refined by the refiners.
研究了针叶木经两台串联的、采用不同功率分配的盘磨机磨浆后纤维形态、浆料滤水、成纸性能以及磨浆能耗的变化。
5) beating energy consumption
打浆能耗
1.
The purpose of this thesis is test the paper quality and beating energy consumption through treat chemi-mechanical pulp with cellulose and xylanase, including study on the effect of enzyme treatment on APMP, P-RC APMP, BCTMP, and to find out the suitable condition with change treatment time, pH value, temperature and dosage.
本论文研究了通过纤维素酶和木聚糖酶预处理化机浆,测试其对成纸强度和打浆能耗的影响。
6) specific refining energy
磨浆电耗
1.
Results showed that,the specific refining energy consumption is decreased with increment of rotation speed of the primary refiner.
结果表明:小叶桉物料在相同条件下进行汽蒸、挤压和化学预浸渍后,分别采用3500 r/min和4000 r/min的盘磨转速进行第一段磨浆,浆料磨至游离度670 mL时所需磨浆电耗与3000 r/min时的相比,分别下降16%和27%;浆料中纤维束含量分别降低20%和35%;第一段磨后浆料再分别经相同盘磨转速(3000 r/min)的后续磨浆后,与相近游离度的浆料性能比较可知,随第一段磨浆盘磨转速的提高,浆料的细小组分含量略有增加,纤维束含量显著降低,强度性能有不同程度的改善,但光学性能变化不显著。
补充资料：耗耗
1.方言。老鼠。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条