1) droplet and film
油滴和油膜
2) OoW(Oils on Water)
油膜水滴
1.
Cooled air,minimum botanic or ester oils and little water were used to form new cutting fluids of OoW(Oils on Water)by means of combined mist-jet.
油膜水滴是使用冷空气、微量可自然降解油剂和少量水,经复合喷雾法形成可自然分解的、新型绿色切削液。
3) oils on water
油膜附水滴
1.
Cooled air, minimum botanic or ester oils and little water were used to form new grinding fluids of minimum oils on water (OoW) by means of combined mist-jet so as to replace traditional grinding fluids.
使用冷风、微量可自然降解油剂 (植物油或酯油 )和少量水 ,经复合喷雾形成的微量油膜附水滴磨削液替代传统磨削液 ,在数控平面磨床上与磨削液分别为微量水、微量油及乳化液、可溶液的磨削加工进行了对比试验。
4) Oils on Water (OoW)
微量油膜附水滴
1.
Experiment Study with Oils on Water (OoW) as Coolants and Lubricants in Green Cutting;
微量油膜附水滴冷却润滑机理应用试验研究
5) oil drop
油滴
1.
The Research on the Size and the Ascending Velocity of Oil Drops Spilling from Tiny Holes of Seabed Pipelines;
海底管线微孔泄漏油滴尺寸与上升速度研究
2.
8% when the average size of oil drop ranges from 21.
2 μm的油滴 ,其分离效率为 84 %~ 99。
3.
The error of charge contained in an oil drop is obtained by means of error transmission method, also the degree of effect on every physical quantity measured directly to the error is analyzed.
用误差传递的方法得到了油滴所带电荷量的误差 ,并分析了各个直接测量量对误差的影响程度 ,同时对仪器结构的改进和实验参数的优选提出了切实可行的方
6) oil drops
油滴
1.
A new method of data processing in Milligan oil drops experiment;
密立根油滴实验数据处理的新方法
2.
The current situation of oil-water sludge,the movement rule of and the forces on the solid impurity particles,oil drops and water of the oil-water sludge in centrifugal force field were introduced,and relevant physical models were established.
介绍了罐底油的现状及罐底油中渣颗粒和油滴及水在离心力场中的运动规律、受力情况,建立了相应的物理模型;推导出了渣颗粒的离心沉降分离速度、沉降层厚度和油滴的向心分离速度、向心层厚度的表达式;通过小型实验设备对罐底油进行了三相分离实验研究,分析了温度、分离转数等对分离效果的影响。
3.
This paper mares some analysis that two factors of oil drop volatilitation in uniform down will influence the experiment of oil drops,and raises some points to be noticed in experiments.
本文分析了油滴的挥发性和匀速下落问题对密立根油滴实验的影响 ,提出了实验过程中该注意的问
补充资料:皂化溶解油、肥皂油和调水油
分子式:
CAS号:
性质:又称皂化溶解油、肥皂油和调水油。金属切削油的一类。一般是淡褐色至深褐以液体或半固体。由在矿物油中加入适量的皂类乳化剂(如钠皂、钾皂、松香钠皂、松香皂或环烷酸钠皂)和少量稳定剂(如乙醇或甲醇)而成。使用时与软水掺合成稳定的白色乳化液。作用以冷却为主,润滑为次。用于车制、锯断、钻孔、磨制等金属粗加工。
CAS号:
性质:又称皂化溶解油、肥皂油和调水油。金属切削油的一类。一般是淡褐色至深褐以液体或半固体。由在矿物油中加入适量的皂类乳化剂(如钠皂、钾皂、松香钠皂、松香皂或环烷酸钠皂)和少量稳定剂(如乙醇或甲醇)而成。使用时与软水掺合成稳定的白色乳化液。作用以冷却为主,润滑为次。用于车制、锯断、钻孔、磨制等金属粗加工。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条