2) Hypoid gear
双曲面齿轮
1.
Based on the Hypoid gear s design as the study object and taken the overlapping coefficient as the objective function,the paper describes the application of one optimum method in use of both mixed-discrete variables to the determination of main parameters for Hypoid gear,which is used to find other geometric parameters.
以双曲面齿轮设计为研究对象,以齿面重叠系数为目标函数,采用混合离散变量最优化方法,确定双曲面齿轮的主要参数,进而计算其它几何参数,Aut CAD 以这些参数绘出零件图,可提高设计效率。
2.
This paper diocussed two method for the calculation of the surface endurance stress of Hypoid gear.
本文讨论了双曲面齿轮齿面接触强度计算的两种方法,它们分别建立在赫兹的点接触和线接触弹性理论的基础上。
4) hypoid gear
准双曲面齿轮
1.
Modeling and FEM Analysis of the Hypoid Gear Based on ANSYS;
基于ANSYS的准双曲面齿轮建模及有限元分析
2.
Tooth Surface Parameterization and Contacting Visualization of Hypoid Gear;
准双曲面齿轮齿面参数化和接触可视化方法研究
3.
Thus,using modified-roll method,4-axis CNC spiral bevel gear machine can manufacture hypoid gear.
这样,在四轴数控铣齿机上可以实现变性法加工准双曲面齿轮。
5) Hypoid gears
准双曲面齿轮
1.
Experimental investigation on running performance of hypoid gears;
准双曲面齿轮副台架性能试验
2.
Based on NC machining principle of hypoid gears, three-dimensional modeling method for CNC machine tool, workpiece and cutter is introduced.
根据准双曲面齿轮数控加工原理,提出了CNC铣齿机、齿轮毛坯和盘铣刀实体模型的具体构建方法;利用简化的齿轮毛坯实体模型和盘铣刀实体模型做布尔减运算,在计算机上实现了模拟工件材料的去除过程;通过加工仿真结果和实际加工结果对比,验证了加工仿真方法的正确性。
6) hypoid bevel gear
准双曲面锥齿轮
1.
This paper researches the design method of shrinkage tooth with equal tip clearance of hypoid bevel gear pair with half generating method, which will increase the contact ratio,engagement factor,load capacity and stability of the transmission.
研究了用半展成法加工的收缩齿等顶隙准双曲面锥齿轮副的设计方法,以求提高齿轮重迭系数、承载能力和传动平稳性。
补充资料：齿轮双面啮合检查仪
见齿轮综合检查仪。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条