1) steel plate directly binding
钢板直接缠绕
3) wrapping wires
缠绕钢丝
1.
This paper gives the calculating formulas for the pre-tension of the wrapping wireswhich considers the effects of the voids in the main cable, and discusses the selection of the timeand the technical requirements for wrapping the main cable with steel wires.
提出了考虑主缆空隙效应的缠绕钢丝预加力计算公式,讨论了选择主缆缠丝时机的条件和缠丝的技术要求算例表明:主缆空隙率和缠绕钢丝的直径与弹性模量是影响缠丝预加力的主要因
4) strip winding
钢带缠绕
5) winding diameter
缠绕直径
1.
The results show that the discharge of microtube was positive to the operating pressure and the winding diameter.
发丝滴头出流流量与工作压力成正比,与发丝微管长度成反比,与发丝微管缠绕直径成正比,并分析了各影响因素与出流量之间的关系。
2.
And the fiber-optic initial loss in different winding diameters,winding pitches and cylinder numbers is researched.
利用单模光纤的弯曲损耗特性,设计了基于光强调制的缠绕式光纤应变传感器,从不同缠绕直径、缠绕螺距和缠绕圈数三方面研究了其与传感器初始损耗的关系,得出了光纤初始损耗随光纤缠绕直径的增大、缠绕螺距的减小和缠绕圈数的增加而增大的结论。
6) rolling diameter
缠绕直径
1.
The Stocker s model was modified with the consideration of various effects due to sub-cooling,area concentration,rolling diameter.
建立以毛细管流动特性仿真为目的的毛细管流动数学模型,模型以Stocker’s模型为基础,考虑入口渐缩、过冷和缠绕直径对流动的影响。
2.
The Stocker s basic model was modified with the consideration of various effects due to sub-cooling, area concentration, rolling diameter, and different equations for viscosity and friction factors.
模型以Stocker s模型为基础,考虑入口渐缩、过冷和缠绕直径对流动的影响。
补充资料:玻璃钢球形气瓶在缠绕中
玻璃钢球形气瓶在缠绕中
玻:K钠球卅’气Hl、在鲤r*中 咯尔#破璃捆研究。t’0稿
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条