1) standard value of foundation bottom pressure
基底压力标准值
1.
Based on the related regulations, the paper states intension and difference between design value and standard value of foundation bottom pressure and shows their calculating expression.
依据有关规范 ,阐述了基底压力设计值与基底压力标准值的内涵及差异 ,给出了它们的计算表达式。
2) design value of foundation bottom pressure
基底压力设计值
3) control figures of maximal means of underlying foundation
基底平均压力最大值
4) base stress
基底压力
1.
Research on the cone penetration resistance of a spread foundation effected by nonlinear distribution of base stress;
基底压力分布对扩展基础冲切承载力影响的研究
2.
By investigating the inner and the outer soil pressure on the cylinder wall and the base stress of the cylinder base,which were obtained from the model experiments,the interactions among the filler inside the cylinder,subsoil and cylinder are analyzed.
在此基础上,提出了沉入式无底圆筒结构基底压力的计算方法。
5) Subgrade pressure
基底压力
1.
Numerical simulation of subgrade pressure and effect of which on structure analysis of foundation;
基础基底压力的数值模拟及其对基础结构分析的影响
6) foundation pressure
基底压力
1.
Sand cushion in different thickness and different foundation pressure results different seismic response.
在研究了砂垫层厚度及基底压力对地面地震反应的影响后,得到了一些有益的结果。
2.
In engineering practice,when a foundation size is small,the foundation pressure can be treated as linear distribution and simply calculated according to formulas of Mechanics of Materials.
在工程实际中,当基础尺寸较小时,基底压力可当作直线分布,按材料力学公式简化计算。
补充资料：平均值-标准值控制图
分子式：
CAS号：
性质：平均值和标准差控制图的一起使用，简记为x-s图。前者用来判断产品质量特性量值的平均值是否处于或保持所要求的水平，后者用来判断产品质量特性值的标准差是否处于或保持所要求的水平。
CAS号：
性质：平均值和标准差控制图的一起使用，简记为x-s图。前者用来判断产品质量特性量值的平均值是否处于或保持所要求的水平，后者用来判断产品质量特性值的标准差是否处于或保持所要求的水平。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条