说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 体电阻
1)  body resistance
体电阻
1.
When machining solar silicon based on EDM,the machining efficiency is determined by silicon body resistance,which is not the same if the conduction mode is different.
电火花加工太阳能级硅,硅的体电阻是影响加工效率的决定因素,而不同的进电方式会使硅有不同的体电阻
2)  bulk resistance
体电阻
1.
The Influence of the Bulk Resistance and Shunt Current on the Characteristics of GaAs Solar Cells;
GaAs太阳电池的体电阻及旁路漏电对电池结特性的影响
3)  volume resistance
体积电阻
1.
The volume resistance and surface resistance measured by three electrodes and the resistance between two electrodes (R) of carbon fiber reinforced cement(CFRC) were studied.
研究碳纤维水泥试块两电极电阻和三电极法测得的体积电阻与表面电阻。
2.
Both volume resistance and contact resistance of the modified composite bipolar plates decreasd obviously after modification.
提出采用膨胀石墨对石墨/酚醛树脂复合板进行表面改性,改性后复合板的体积电阻和接触电阻都有显著降低。
4)  volume resistivity
体电阻率
1.
The results indicate that measured SE of the system increases and the volume resistivity decreases sharply with increasing of doped PAN.
研究结果表明,随着聚苯胺加入量的增加,体电阻率明显下降,屏蔽效能稳定提高。
5)  liquid resistance
液体电阻
1.
As the axial fan has 4000 hr per year regulated speed in motion in Anqin Copper Mines Xifeng Well, so applied reconstruction of liquid resistance regulated speed technology, it can recomize power cost RMB 200 thousand.
 安庆铜矿西风井轴流风机由于每年有4000小时可调速运行,所以采用液体电阻调速技术进行改造,每年可节约电费支出近20万元。
2.
Thte starting characteristics of mine fan driven by coiled asynchronous motor in series connection with symmetric liquid resistances to the rotor is analysed,and the calculating method of liquid resistance is introduced.
分析了矿井通风机由绕线式异步电机拖动时电机转子串接对称液体电阻的起动特性,并介绍了液体电阻的计算方法。
3.
To meet the needs of different applications and loads, the conventional starting mode of the high-voltage cage liquid resistance starter is improved.
为满足不同应用场合和负载的要求,对传统的高压笼型液体电阻起动器的起动方式进行了改进。
6)  self-resistance
本体电阻
1.
Influence of the self-resistance on the linearity of humidity sensitive resistor;
湿敏电阻器本体电阻对线性度的影响
补充资料:比体积电阻
分子式:
CAS号:

性质:又称比体积电阻。边长为1cm的立方体的体积电阻,以表示。表征绝缘介质电性能的主要指标。它与材料结构、组成、杂质含量、环境温度和湿度等有关。对陶瓷介质材料希望其数值越高越好。表达式为体积电阻率ρν=RV·(S/L)(式中,RV为测得的试样电阻值;S为电极面积;L为试样厚度),单位为Ω·cm。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条