1) enhanced hybrid post-processing procedure
杂交化后处理
1.
In this paper, a new simple enhanced hybrid post-processing procedure is presented to improve stress solutions of displacement-based generalized conforming membrane elements.
本文主要针对应力杂交化后处理方法在广义协调平面膜元中的应用进行了一些研究,在结合位移元和杂交元的特点基础上,通过两种方法假设应力场,利用杂交元原理对原位移型膜元的应力解进行了重新计算。
2) chemical processing
化学后处理
1.
Study on chemical processing for down fabric;
羽绒织物化学后处理工艺研究
3) post-oxidation
后氧化处理
1.
To improve the anti-corrosivity of 40Cr steel after plasma nitrocarburizing,the post-oxidation treatment was carried out to the nitrocarburized specimens in an adiabatic plasma heat-treatment furnace where the oxidizing gas is in different H2/O2 ratios.
为了进一步提高等离子软氮化后40Cr钢的耐蚀性能,对等离子软氮化的试样进行了后氧化处理。
2.
The corrosion resistance of Al_2O_3 coating is two times of the general AI2O3 coating, the Al and Ni in the post-oxidation coating change to the oxide of the Al and Ni, therefore the composition and structure was change
本文对以(Ni/Al+Al)为底层,以Al_2O_3为工作层的陶瓷层,经后氧化处理得到的Al_2O_3涂层,在5%HCL内的腐蚀行为进行了研究,研究结果表明,后氧化Al_2O_3涂层的耐蚀性较一般Al_2O_3涂层提高2倍以上;后氧化处理使涂层内单质Al、Ni转变成Al、Ni的氧化物,从而改变涂层的成分和结构,改善了涂层的耐蚀性。
3.
In order to improve the corrosion resistance of 40Cr steel after plasma nitrocarburizing,post-oxidation treatment was carried out with different oxidizing gases in the furnace and oxidizing treatment out of the furnace(salt bath,alkali solution and steam).
为了进一步提高离子氮碳共渗后40Cr钢的耐蚀性能,对离子氮碳共渗后的试样进行了后氧化处理。
4) commercialized treatment after adopting
采后商品化处理
5) Chemical treatment after separation
选后化学处理
6) treatment methods after formation
化成后处理方法
补充资料：奥氏体化处理
austenitizing：在热处理中，将钢或其它铁基合金加热使其组织部分或全部转变为奥氏体或者再使奥氏体成分均匀化的操作。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条