1) Tool preparing system
刀具准备系统
2) cutter preparation
刀具准备
1.
Aimed at the spaceflight products featured single-piece and versatile production and defects of the traditional serial cutter preparation mode,a new parallel cutter preparation mode were proposed and carried out based on CAPP and DNC systems,and the cutter parameters post-process programming template adapted various NC systems was developed.
针对航天产品单件多品种生产的特点和传统的串行式刀具准备模式的缺陷,提出并实现了一种基于CAPP系统、DNC系统的并行式刀具准备模式,并开发了适应不同数控系统的刀具参数后处理程序模板。
3) tool system
刀具系统
1.
Investigation of method for unbalance suppression of tool system with high rotational speed;
抑制高速旋转刀具系统不平衡量的方法研究
2.
When high speed cutting,the life of tool,machining accuracy,efficiency and surface roughness of the workpieces are directly influenced because rotational speed of tool system are very high.
高速切削时,由于刀具系统的转速很高,刀具系统的不平衡会影响刀具寿命、加工精度和效率。
3.
The reasons of vibration of high-speed tool system in cutting are analyzed theoretically.
本文从理论上分析了高速加工刀具系统在工作过程中发生强迫振动的原因,并提出减小刀具系统振动的措施。
4) tooling system
刀具系统
1.
According to rotor balancing theory, the paper provides guidance for tooling system's design, production and usage by analysing to select the correcting plane number, to locate the correcting place position and to choose the balance technique etc.
运用转子平衡理论,对刀具系统实施平衡技术时,分析了校正面数量的选择、校正面位置的确定、平衡方法的选择等平衡工艺的主要方面,为刀具系统的合理设计、制造和使用提供指导。
5) cutting tool system
刀具系统
1.
Based on the function analysis, the cutting tool system can be divided into shaft module, middle module and working module.
对机械加工刀具系统进行模块化分析,在功能分析基础上将刀具系统模块划分为主柄模块、中间模块和工作模块三部分。
6) cutting tool and cutting tool system
刀具与刀具系统
补充资料：设备安装前的准备工作——技术准备
| 设备安装前的准备工作——技术准备 | ||
|
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条