1) big and small intermediate gears assembly
大小过轮装配
2) bolted type built-up gear
螺栓装配式大齿轮
3) turbine assembly
涡轮装配
1.
The influences of turbine assembly including the radial beat as well as the head face of turbine disk, the assembly angle of turboshaft, the agreement of general assembly with dynamic balance and the concentricity of three supporting points on the librations of motor are introduced in this paper.
介绍了涡轮装配对发动机振动的影响,分析了涡轮盘的径向偏摆、端面偏摆、涡轮轴装配角度、总装装配与动平衡前装配一致性、三支点同心度对发动机振动的影响及相应的控制措施。
4) tyre assembling
轮胎装配
5) interference fit
过盈装配
1.
The deformation of journal bearings produced by interference fitting,oil film temperature and pressure was simulated by ANSYS.
利用ANSYS软件对滑动轴承在过盈装配和油膜压力与温度的作用下轴承套产生的几何变形进行了模拟仿真。
6) assembly process
装配过程
1.
Research on key technology of hydraulic manifold block assembly process simulation system
液压集成块装配过程仿真系统关键技术研究
2.
A theory and method of collaborative design of product assembly structures and assembly processes is ad- dressed.
从产品装配结构和装配过程协同设计的角度出发,提出产品装配效率和产品装配复杂度等评价指标,建立产品装配性综合评定体系,采用知识库和网络技术实现网络环境下的产品装配结构分析和再设计。
3.
According to the damages of oil-film bearing taper sleeve with elastic cohesion on hot continuous strip mill in some large steel company,3D boundary element method(BEM) for elastoplastic contact problems was used to qualitatively analyze the mechanical behaviors of sleeve and roll neck during the assembly process.
针对国内某大型钢厂热连轧机组弹性结合油膜轴承在装拆与使用过程中的锥套损伤问题,利用三维弹塑性接触问题边界元法定量分析了轧机油膜轴承锥套与轧辊辊颈过盈装配过程中的力学行为特性,分别建立了锥套在冷推进和不同阶段液压胀形力作用下的加载模型,相应地编制了三维边界元程序,模拟了锥套装拆过程,计算了锥套在不同液压胀形作用下的母线变形图,得出了不同阶段液压胀形推进下的接触应力分布规律和变形规律。
补充资料：小过
1.稍微逾量。 2.小的过错。 3.今机关﹑工厂﹑学校等单位对犯错误者的一种行政处分。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条