1) Milling Resistance Torsion
切削阻力矩
1.
Toll s arrangement Style of Pavemill and Calculation of Milling Resistance Torsion;
路面铣削装置的刀具排列形式与切削阻力矩计算
2) cutting resistance
切削阻力
1.
The results testified the feasibility of the cutting mechanism and showed the sequences of test factors according to the influence on cutting resistance and cutting-out ra.
试验结果检验该半旋转切削机构的可行性及分析得出了影响切削阻力试验指标和切削成功率试验指标的主、次试验因素。
2.
The result of experimentation can be expressed as follows:The cutting resistance increasing rapidly in the beginning of cutting into the stock,it comes to the max when cutting about 2mm into the stock,then decreasing slowly.
实验表明:切削阻力在进入砧木初期迅速增大,在切深2mm左右达到最大,以后逐渐减小;切削阻力在试验条件下小于300N。
3.
On the basis of experiments, the experimental results show the limitedload of anti-compression, the highest cutting resistance and the minimum cutting line-speed, and show that the diameter of se.
试验结果得出毛桃树苗抗压伤极限载荷、毛桃苗切削最大阻力和刀片的最小极限切削线速度;以及影响毛桃苗切削的因素关系,苗木直径、转速、滑切角依次影响切削阻力大小,苗木直径与切削阻力呈平方关系;转速与切削阻力呈线性关系;滑切角与切削阻力也呈线性关系。
3) Cutting obstruction moment
切割阻力矩
4) Wood cutting resistance
木材切削阻力
5) Cutting torque
切削扭矩
6) milling moment
铣削力矩
补充资料：肺循环阻力(或全肺阻力)
肺循环阻力(或全肺阻力)
pulmonary circulation resistance
血液在肺部血管内流动时和血管壁之间的摩擦力和血液内部的摩擦阻力。肺动脉管壁较薄，分支短而管径大，故肺动脉的可扩性较大，对血流的阻力很小，仅0.12PRU(外周阻力单位)。肺循环动脉部分总的阻力和静脉部分总的阻力相等，故血液流动时在动脉部分的压力降落和静脉部分的压力降落相等。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条