1) The thermal induced errors of spindle
主轴热误差
1.
The thermal induced errors of spindle is a main source of machining errors.
本文提出了一种基于自组织原理的主轴热误差补偿策略,它只需根据对主轴热倾斜状态的定性测量结果即可进行定量误差补偿,从而可以大大降低对误差测量精度的要求及测量成本,同时各补偿力间的协调关系根据自组织原则自动建立,简化了补偿算法。
2) Spindle error
主轴回转误差
1.
In this paper,a testing system of the spindle error is proposed based on LabVIEW.
以LabVIEW软件为平台,设计了主轴回转误差实验测试系统。
4) spindle rotation induced error compensation (SREC)
主轴回转误差补偿
5) Rotation error measurement of spindle
主轴回转误差测量
6) axial error
轴向误差
1.
To meet the requirement of 100% on-line inspection of gears in mass production in automotive and motorcycle industry, the two-flank principle is used to check the gear radial errors(thickness, radial composite error, run-out and error burs)and the gear axial errors(mean helix error, helix error and taper error)to realize the quick on-line inspection of gear machining flaws.
针对汽车、摩托车齿轮生产企业大批量齿轮生产现场,实现在线100%快速检测需要,本项目采用双面啮合原理测量齿轮的径向误差(齿厚、径向综合偏差、径向跳动、毛刺等)和轴向误差(平均齿向偏差、齿向偏差、锥度误差),实现齿轮的制造缺陷的现场快速检测。
2.
This paper, part seven of "Analysis of Errors and Inspection Groups on Hobbing Gear", dis- cusses the reason why the axial error occurs, the mathematical model and the relation between tol- erance group Ⅲ and axial error.
这部分的主要内容是论述轴向误差的产生原因,数学模型以及轴向误差与第Ⅲ公差组之间的关系。
3.
In this paper,the existing best-fit calculation,so as to the existence of axial RMS minimum goal for the design of the match,the current method of calculating the axial error is discussed,pointing out that some places a little unreasonable,a more accurate calculation of the axis to the formula for calculating the error and gives the derivation process.
针对现有的吻合计算,存在以轴向RMS最小为设计目标的吻合,对目前计算轴向误差的方法进行了讨论,指出了某些稍不合理的地方,提出了一个较为准确的计算轴向误差的计算公式,并给出了推导过程。
补充资料:惯量主轴
见惯量张量。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条