1) staggering tooth
错齿
1.
In order to reduce the probability of failure, the influence of a gearwheel with staggering tooth on the meshing stiffness of gear with double circular arc was investigated.
对错齿双圆弧人字齿轮的啮合刚度进行了分析和定量计算 ,并对比了错齿后和未错齿时的刚度变化值 ,为分析错齿双圆弧齿轮的振动特性奠定了基础。
2) offset strip fin
错齿翅片
1.
Experimental studies on the air-side heat transfer and pressure drop characteristics for offset strip fins were performed.
对9种不同结构参数的错齿翅片进行传热和流动阻力性能试验,分析比较翅片的间距、高度和节距等结构参数对其传热因子和阻力性能的影响。
3) Staggering tooth coefficient
错齿系数
4) crisscross
交错齿
1.
The flow and pressure pulsation can be reduced by about 70% with crisscross spurs structure, While the output volume can be increased by about 10% with asymmetric spur profiles, the pump noise can be also reduced.
为提高齿轮泵排量、降低流量脉动率,就齿轮泵进行新齿形及新结构改进设计,提出采用交错齿结构,流量脉动率可降低70%左右,采用非对称高齿齿形排量可增大10%,同时又可降低噪音。
5) flat billet
平错齿饰
6) stagger tooth milling cutter
错齿边铣刀
参考词条
补充资料：齿错
1.如牙齿上下交错。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。